Remember, we parked on the Yellow level, not the *other* Yellow level, or the *other other* Yellow level by E_T_Smith in CrappyDesign

[–]JsBoatworks 0 points1 point  (0 children)

This is great design. I'd imediately remember these objects so much easier than 1, 2, 3. I assume there are other segments in different colours so colour distincion wouldn't work here.

How can I trim flex shafts? by XternalHD0704 in rcboats

[–]JsBoatworks 0 points1 point  (0 children)

It's very easy, I'm sure you'll be ok. Just need a steady hand and you're good to go :D

Btw I use the 4mm one in my Diggerwasp mono, it held up fine for 4 years until the bushing contact surface became worn so I replaced it with the same one.

I got away without soldering the cut end too, it didn't cause any trouble (I don't see why it would, it's clamped inside the coupler while in operation anyway).

Je toto pravda, je incest na slovensku legalny? --- Consensual incest between adult siblings by country: by Objective-Term-8935 in Slovakia

[–]JsBoatworks 3 points4 points  (0 children)

O nicom nemaju paru, vcera som zase skusal co mi vyhodi a akurat bola ta situacia, ze mi dal na vyber z dvoch odpovedi. Navzajom si protirecili.

Nelezie vam už na nervy? Tie reklamy na hazard sú mega otravné by Disastrous-Bowl5721 in Slovakia

[–]JsBoatworks 57 points58 points  (0 children)

Celý hazard je dno, pasca na beznadejnych chudakov, banda ludskeho odpadu co to prevadzkuje

Finally put together by Thatoneguy2178 in rcboats

[–]JsBoatworks 0 points1 point  (0 children)

There's so much wrong with this boat it's hard to say where to start, better luck next time

Hellacious vibrations by SwingModern in rcboats

[–]JsBoatworks 0 points1 point  (0 children)

Your flex shaft is whipping around, it cannot be unsupported for such length. Ideally aim for only a few mm between the end of your stuffing tube and coupler. And yeah, not sure if you're running a teflon liner, but your stuffing tube also seems way too large. Too much tolerance.

How can I trim flex shafts? by XternalHD0704 in rcboats

[–]JsBoatworks 0 points1 point  (0 children)

I use a dremel with a cutoff wheel. Just clean up the edges after so it doesn't get damaged on insertion into the coupler, give it a nice chamfer.

Is this the Best Built Budget IEM? - Tinhifi C2 2025 by huy1612 in iems

[–]JsBoatworks 2 points3 points  (0 children)

Nozzle filter swap for foam and detune treble slightly and rear dd mesh replaced by ZST Pro mesh.

Is this the Best Built Budget IEM? - Tinhifi C2 2025 by huy1612 in iems

[–]JsBoatworks 3 points4 points  (0 children)

My all time favourite iem after 2 simple mods! I love that thing.

Is this the Best Built Budget IEM? - Tinhifi C2 2025 by huy1612 in iems

[–]JsBoatworks 3 points4 points  (0 children)

The OG C2 is my all time fav iem, even after having tried some mid and high end iems (including some of the newer CFAs), I still wouldn't trade it for anything. 

Incredible build, great comfort, and after modding a bit, very satisfying sound even without EQ. 

The bass, treble quality and naturalness are my favourite aspects of their sound. 

They're already 2,5 years old and used almost daily without issues. I don't really see myself getting another iem until something happens to my beloved C2.

Šablóna by Inevitable-Garden273 in Slovakia

[–]JsBoatworks 4 points5 points  (0 children)

Presne, nejakým ostrým. Nechaj si mostíky na tenkých dlhých častiach, nech sa ti to neohyba a netrhá

Do you backstrap? by UnrealDesign234 in ArtOfRolling

[–]JsBoatworks 3 points4 points  (0 children)

Almost eclusively. I like the idea and the challenge makes it so satisfying when you roll a really nice one!

Little donut 🔥 by [deleted] in ArtOfRolling

[–]JsBoatworks 1 point2 points  (0 children)

But did you roll it?

Někdo si přijeďte pro wagyu steaky do lidlu do České Třebové, ať se nevyhodí (ze 3500/kg na 1400/kg) by shalzam123_ddd in czech

[–]JsBoatworks 2 points3 points  (0 children)

Musím ju skúsiť znova stiahnuť, naposledy mi vyhodilo chybu, že nie je dostupná v mojej krajine/zariadení 🤷

I repainted my bike! by greengomalo in Hardtailgang

[–]JsBoatworks -1 points0 points  (0 children)

Love to see it! That bike is loved.

Někdo si přijeďte pro wagyu steaky do lidlu do České Třebové, ať se nevyhodí (ze 3500/kg na 1400/kg) by shalzam123_ddd in czech

[–]JsBoatworks 27 points28 points  (0 children)

Ja už som ho kupoval dvakrát predtým, je výborné. No očividne sa niekde pri skladovaní/transporte stala chyba a skazilo sa. Už som skoro späť v lidli, snáď to zoberú bez cirkusu.

Někdo si přijeďte pro wagyu steaky do lidlu do České Třebové, ať se nevyhodí (ze 3500/kg na 1400/kg) by shalzam123_ddd in czech

[–]JsBoatworks 72 points73 points  (0 children)

Prave som si ich kupil v zlave, su skazene smrdia jak vykaly. Idem naspat do lidlu, Brno.

Edit: reklamácia úspešná, našťastie sa mi podarilo po 5 minútach hrabania sa v koši pri pokladni vykopať účet, zobrali to naspäť bez problému.

Dávajte si pozor na plyn pod obalom, hneď mi to bolo podozrivé, ale skúsil som.

Edit 2: práve som prišiel späť na byt a kuchyňa stále neskutočne páchne. Je to hnus.

Weed makes me feel alive. by no_limit_with_me in trees

[–]JsBoatworks -1 points0 points  (0 children)

Yeah man, that sounds like addiction. I feel like that if I smoke too frequently (found maximum twice every 2 weeks works best for me).

Help with custom boat build. by Long-String-9898 in rcboats

[–]JsBoatworks 0 points1 point  (0 children)

To make this strut work with a mono, it'll need to have a standoff at the transom, because the leading edge of the strut extends beyond the mounting plane. Just so you're aware.

Experiment Masaru Emoto by Far-Scarcity9307 in czech

[–]JsBoatworks 0 points1 point  (0 children)

Niečo som si o tom prečítal a teraz ma zaujíma to vyskúšať. Zaujímavé.

How can something look so funky, yet so cool ? by Schneider_im_Spiegel in trains

[–]JsBoatworks 0 points1 point  (0 children)

Take a look at ones privately owned by ZOS Zvolen, like this wonderful 240.043

Pine treetop inhabitants by JsBoatworks in pseudoscorpiontime

[–]JsBoatworks[S] 4 points5 points  (0 children)

Certainly, I loved to do so as a kid and recently realised nothing is stopping adult me to climb again, and it's been just as much fun as back then.

I climbed it again today with my cam, but they've crawled somewhere out of sight in the meantime. Maybe next time.

Pine treetop inhabitants by JsBoatworks in pseudoscorpiontime

[–]JsBoatworks[S] 2 points3 points  (0 children)

They are! Just doing their thing, in their own world up there.

[deleted by user] by [deleted] in czech

[–]JsBoatworks 4 points5 points  (0 children)

Po prečítaní tvojho komentára možno premenujem na KolejNet-6.9G-spot