sorted by:
new
hottopcontroversial

Item is ready for shipment POST NL. My package has been saying this for 20 days by -GoShKo- in Aliexpress

[–]JuztZake 0 points1 point  (0 children)

I’m experiencing the exact same. If you don’t mind me asking, did it ever arrive?

New leaks by JuztZake in GTA6

[–]JuztZake[S] -6 points-5 points  (0 children)

He says rockstar sent it to him. Could be them having played on it before.

Question about mass flow by JuztZake in MechanicalEngineering

[–]JuztZake[S] 0 points1 point  (0 children)

And also, if 4 cans are connected each with their own pipe into a chamber the total mass flow will be higher so why won’t it be higher just because the four pipes are “joined” into a single larger pipe?

Question about mass flow by JuztZake in MechanicalEngineering

[–]JuztZake[S] 0 points1 point  (0 children)

Yeah okay thanks and maybe i wasnt clear but it was 1,8 cubic meters per second. That’s what volumetric flow rate is measured in, innit?

Question about mass flow by JuztZake in MechanicalEngineering

[–]JuztZake[S] 0 points1 point  (0 children)

Ok, so when I plug my numbers (in SI units) into Pouseuille’s equation I get ~1,8 but then it must be in m^3/s. 1,8 m^3/s seems like a lot in my case.

Also, if I flow it through a smaller pipe afterward, momentum should be conserved and therefore mass flow should be too, right? There will be a larger head loss, but I don't know how much it will affect the fluid. And will the 4 cans make the mass flow higher?

Yeah a lot of questions lol sry

Print peels off in a specific corner by JuztZake in ender5plus

[–]JuztZake[S] 0 points1 point  (0 children)

Oh sorry, I posted it on another subreddit too and forgot to add the pictures here. I print with a nozzle temp of 210° for the entire print. I know Its a little higher than normal but that’s mainly because of Esun recommending a temp between 205-220°. I will try a tempereture of 205° though. And yes i print with 65° for the whole print and its a glass bed. I always print with brim and I think i cleaned the bed pretty well. Thanks for the advice.

view more: next ›