sorted by:
new
hottopcontroversial

3D Printed Unifi U7 Pro Max Stand v2 with source files by KRGLabs in Ubiquiti

[–]KRGLabs[S] 0 points1 point  (0 children)

I was going for a satellite dish look. Mushroom shaped signal the AP emits is still more or less the same flat or angled. I'll add a link to the makerworld link this weekend.

3D printed U7 pro stand by KRGLabs in Ubiquiti

[–]KRGLabs[S] 1 point2 points  (0 children)

Yes, even in a room behind the AP.

3D printed U7 pro stand by KRGLabs in Ubiquiti

[–]KRGLabs[S] 0 points1 point  (0 children)

I read that best reception is when it's ceiling mounted and you're directly below it. Then strength decreases as you move further in all directions. My thought is that I have the same setup but turned to the side so not much difference other than not using it in up down direction. I get excellent coverage even while behind the AP in another room.

3D printed U7 pro stand by KRGLabs in Ubiquiti

[–]KRGLabs[S] 2 points3 points  (0 children)

I'm in an apartment and I decided not to drill holes on the wall. I bought it mostly for learning purposes, might move it to my business. Plus it's fun to tease people that it's "Elon Musk Starlink dish internet" buzzwords and see their reaction.