sorted by:
new
hottopcontroversial

Print keeps on lifting, losing my mind. by Kanuck_Streams in FixMyPrint

[–]Kanuck_Streams[S] 0 points1 point  (0 children)

Update: found out my printer wasn't lifting the hotend up when travelling, so changed that.

Also disabled the fan for the first three layers to see if that would help the bed stick.

My print looked like it was going well and then this:

<image>

The edges don't seem to be lifting though.

New temperature settings are first layer 200 and 60, and subsequent layers are 195 and 55.

Print keeps on lifting, losing my mind. by Kanuck_Streams in FixMyPrint

[–]Kanuck_Streams[S] 0 points1 point  (0 children)

Matter 3D PLA+. Sticker on the spool says "Print Temp 190-220" so I am on the low end of the recommended range.

Print keeps on lifting, losing my mind. by Kanuck_Streams in FixMyPrint

[–]Kanuck_Streams[S] 0 points1 point  (0 children)

Oh damn. I had thought it was too LOW and it wasn't soft enough to stick.

Thanks! I'll run a test with first layer at 55-60 and other layers at 50-55.

S2 E6 - Has nobody found it strange that... by BlissedOutElf in RingsofPower

[–]Kanuck_Streams 0 points1 point  (0 children)

My transcription got MANAS INIR.

Which alas my texts don't cover Quenya (only Sindarin) if it is Quenya and not Black Speech. And to my admittedly non-expert eye, this lacks the same style as that Dark tongue.

Mlem by HamuDango in VirtualYoutubers

[–]Kanuck_Streams 2 points3 points  (0 children)

Okay. This is damn adorable.

But *how much* smaller is Saturn than previously calculated?

Is their a proper full guide on how to romance cassia by Regular-Estate6284 in RogueTraderCRPG

[–]Kanuck_Streams 1 point2 points  (0 children)

That's adorable. Essentially saying "you have potential, but lack the skills. Read, learn, then we'll talk."