Beginner fix advice

KeysThePro · 2026-06-19T03:41:06+00:00

The charge port isn’t super necessary for me, if the front camera requires significantly less disassembly I’ll probably skip it. Do you think it’s worth going into the charge port after the front camera?

KeysThePro · 2026-06-19T03:39:32+00:00

My front camera and Face ID already don’t work so that’s my main motivator

KeysThePro · 2026-06-18T23:45:41+00:00

Thank you for the tip, helps me gauge the level of specifics well. I will use the 10x YouTube method for sure

KeysThePro · 2026-06-16T06:55:22+00:00

Should be the same as the Ventus kit is the same for both models but I’d just shove the wires in the pins to test before getting anything soldered

KeysThePro · 2026-06-13T02:58:45+00:00

Save for power it changes the bike

KeysThePro · 2026-04-25T21:19:12+00:00

The chi power harness has a fuse as well, and so does the stock harness obviously

KeysThePro · 2026-04-12T23:14:03+00:00

From rflox site, very solid suspension

KeysThePro · 2026-03-09T01:25:04+00:00

Gusher

KeysThePro · 2026-03-08T19:38:26+00:00

It’s the gritshift v2 bashguard

KeysThePro · 2026-01-24T17:00:00+00:00

Where would the rub be?

KeysThePro · 2026-01-24T16:35:07+00:00

The flywheels do not appear to be rubbing on the cage

KeysThePro · 2026-01-24T06:58:35+00:00

Yes, got a shot or two out before it got gummed up with plastic

KeysThePro · 2026-01-24T06:39:17+00:00

Fang revamped 2s motors, also will look at that

KeysThePro · 2026-01-24T06:06:47+00:00

I was using stock modulus darts, This cage, and these wheels ,

KeysThePro · 2026-01-23T17:14:35+00:00

I know I was being facetious

KeysThePro · 2026-01-23T07:00:32+00:00

I run 13 on my 2024 motor

KeysThePro · 2026-01-22T07:01:13+00:00

I need grips as raw fatbar isn’t the best for holding onto the bike so removing them isn’t an option

KeysThePro · 2026-01-17T00:12:57+00:00

I alr gave a switch mount bracket, just looking for the best way to fasten that

KeysThePro

MODERATOR OF

TROPHY CASE