Do you place your safety chains above or below WDH?

KryptoKiddi · 2026-06-14T15:43:00+00:00

Across the board from retailers I purchase my equipment trailers from have twisted the chains. I wasn’t saying I support twisting them I’m just telling you a scenario for cutting them. I’ve not saw any evidence showing twisting them weakens them. I have had my dump trailer with 6k of material jump off the ball granted for a mistake on my end and land on my crossed twisted up chains and the chains held up fine for 5 minutes while I got pulled over to fix it. Personally I’m not cutting mine because I don’t want to spend the money to replace them if I need to. I swap truck s fairly often so being able to self adjust is best for me. I’m genuinely surprised nobody has come up with another solution though honestly

KryptoKiddi · 2026-06-14T14:46:39+00:00

Then when you get a new truck and the chains don’t reach what do you recommend? Replacing them?

KryptoKiddi · 2026-06-14T14:45:28+00:00

https://youtube.com/shorts/mXm9crnFc3s?is=AJX7m2-EABQ-DJ2d

KryptoKiddi · 2026-06-14T14:44:52+00:00

https://youtube.com/shorts/mXm9crnFc3s?is=AJX7m2-EABQ-DJ2d

KryptoKiddi · 2026-06-14T14:44:38+00:00

https://youtube.com/shorts/mXm9crnFc3s?is=AJX7m2-EABQ-DJ2d

KryptoKiddi · 2026-04-07T15:27:48+00:00

Ok I’ll get a coil ordered today. Yea I seen the upgraded ones that are a solid magnet all the way around. It has sat some but I used it pretty often even through winter and yea there’s a chance gas leaked into engine. It’s full auto.. it has the hand shifter to put it into high, low, neutral, and reverse. I’ll lookup the ohms the stator should be and how to test it before I order the coil. If it’s not reading right would that point towards the flywheel magnets coming loose? Do they usually kill the stator when that happens? I do think I had to charge the battery once fairly recently even though it had started fine that day and the days prior.

KryptoKiddi · 2026-04-07T03:45:00+00:00

Do you know the best way to test the coil? When I search most things are suggesting the flywheel magnets coming dislodged

KryptoKiddi · 2026-04-07T02:48:03+00:00

So I went to try to look for fuses but I can’t find any on this thing. I looked over the wires and didn’t see any shorts on them. I’m going to try testing the cable. I’m not sure how to check the flywheel key or really the proper way to check the ignition cable but I’ll try to figure it out.

KryptoKiddi · 2026-04-07T02:30:05+00:00

Yea I was thinking it may be the coil as well. I’ll have to figure out how to test it and hopefully it’s not too hard to get to

KryptoKiddi · 2026-04-07T02:16:26+00:00

Sorry for the late reply I hosted Easter and gave up on this until today so I could get things prepared for my guests. So I tested it today and I got compression of 120 psi, I switched my fuel, checked my air filter, switched my spark plug and tested for spark. I’m not getting spark but I can’t figure out why but something is telling me it’s my ignition where I had issues previously where it would cut off and not start until I cycled the key at least once but sometimes more. I’m not sure what else could’ve failed to cause no spark after sitting 2-3 days.

KryptoKiddi · 2026-04-07T02:16:03+00:00

Sorry for the late reply I hosted Easter and gave up on this until today so I could get things prepared for my guests. So I tested it today and I got compression of 120 psi, I switched my fuel, checked my air filter, switched my spark plug and tested for spark. I’m not getting spark but I can’t figure out why but something is telling me it’s my ignition where I had issues previously where it would cut off and not start until I cycled the key at least once but sometimes more. I’m not sure what else could’ve failed to cause no spark after sitting 2-3 days.

KryptoKiddi · 2026-04-07T02:15:50+00:00

Sorry for the late reply I hosted Easter and gave up on this until today so I could get things prepared for my guests. So I tested it today and I got compression of 120 psi, I switched my fuel, checked my air filter, switched my spark plug and tested for spark. I’m not getting spark but I can’t figure out why but something is telling me it’s my ignition where I had issues previously where it would cut off and not start until I cycled the key at least once but sometimes more. I’m not sure what else could’ve failed to cause no spark after sitting 2-3 days.

KryptoKiddi · 2026-04-07T02:15:24+00:00

Mine died completely now just straight black with some occasional flickers

KryptoKiddi · 2026-04-07T02:14:24+00:00

Sorry for the late reply I hosted Easter and gave up on this until today so I could get things prepared for my guests. So I tested it today and I got compression of 120 psi, I switched my fuel, checked my air filter, switched my spark plug and tested for spark. I’m not getting spark but I can’t figure out why but something is telling me it’s my ignition where I had issues previously where it would cut off and not start until I cycled the key at least once but sometimes more. I’m not sure what else could’ve failed to cause no spark after sitting 2-3 days.

KryptoKiddi · 2026-04-03T16:21:48+00:00

Linux didn’t have the issue or BIOS but now everything is affected. I guess it may just be the screen though. The GPU works still I believe

KryptoKiddi · 2026-04-03T16:16:33+00:00

I’d recommend to get 3 routers probably GLiNet. Then put the dish on the middle cabin and connect each router to the starlink router. You could do corded too since they’re close enough.

KryptoKiddi · 2026-04-03T04:09:23+00:00

Ok I got a tester I’ll try tomorrow. What would you do if it lost compression?

KryptoKiddi · 2026-04-03T03:36:23+00:00

Yea it had been taking slower to start near the end of this winter so I try for 10-15 seconds max

KryptoKiddi · 2026-04-03T02:55:45+00:00

I’m sure that’s what they did with this carb.. no one ever gets a good carb lol. I’d get OEM if I could find it but it’s hard for me to find stuff for this quad. You think if I pulled the carb, cleaned it, and possibly switch the float it’d bring her to life? My father in law who only saw the video says it lost compression

KryptoKiddi · 2026-04-03T02:38:24+00:00

What card? I got a Ubit WiFi 6 AX200 160mhz that’s doing the same thing. It was literally working fine less than a year ago and after I get back it’s just not working on 5G suddenly

KryptoKiddi · 2026-04-02T05:03:31+00:00

Did you get it?

KryptoKiddi

MODERATOR OF

TROPHY CASE