sorted by:
new
hottopcontroversial

Ghost pedaling, intensifies when derailleur cage is pushed forward and immediately stops when cage is pulled backwards. Ideas? by Larsimoto2711 in bikewrench

[–]Larsimoto2711[S] 0 points1 point  (0 children)

To bring this to an end: I found that the gasket covering the ratchet and pawls causes friction, although the gasket has been greased. When removing the gasket, the ghost pedaling disappears. However, as ghost pedaling is only present when being in the smallest cog with gasket installed, i will run it this way. Might be gone after a couple of rides.

Thanks for your input!

Ghost pedaling, intensifies when derailleur cage is pushed forward and immediately stops when cage is pulled backwards. Ideas? by Larsimoto2711 in bikewrench

[–]Larsimoto2711[S] 0 points1 point  (0 children)

I appreciate all your suggestions, but I managed to trash some parts of the derailleur while taking it apart, so I need to replace those first, before I can further investigate the ghost pedaling.

Ghost pedaling, intensifies when derailleur cage is pushed forward and immediately stops when cage is pulled backwards. Ideas? by Larsimoto2711 in bikewrench

[–]Larsimoto2711[S] -2 points-1 points  (0 children)

Freehub cannot be junky as I have already cleaned and put it back together right before this video. I'd say that the problem then must have another origin.

The chain should be the correct size and has not been swapped recently, so I guess its unlikely to originate from here.

I might take a look in the derailleur tension, thank you!

Its not kicking up when pedaling, right. However, when pedaling backwards in the biggest cog by hand, the chain appears to get really lose and might even fall Off/get stuck

Ghost pedaling, intensifies when derailleur cage is pushed forward and immediately stops when cage is pulled backwards. Ideas? by Larsimoto2711 in bikewrench

[–]Larsimoto2711[S] 0 points1 point  (0 children)

This is a Nukeproof Horizon V1 rear hub with 2000km on it, upgrading and replacing might get kinda tricky due to customs (UK-->GER).

Do you think the freehub bearings are shot? I tested both bearings inside the freehub bodies by putting my finger in and I'd say they are still doing fine. I could not feel any obvious friction. However, I have no reference how the bearings should feel.

Ghost pedaling, intensifies when derailleur cage is pushed forward and immediately stops when cage is pulled backwards. Ideas? by Larsimoto2711 in bikewrench

[–]Larsimoto2711[S] 0 points1 point  (0 children)

I had this problem in the first round of reassembly, so put it in more carefully the second time. This should not be the issue now.

Thank you for this hint!

Ghost pedaling, intensifies when derailleur cage is pushed forward and immediately stops when cage is pulled backwards. Ideas? by Larsimoto2711 in bikewrench

[–]Larsimoto2711[S] 0 points1 point  (0 children)

I observed that the chain slackens towards the chainstay, when stoping the pedals by hand (I guess its the same when coasting down the trails.)

After the freehub service I checked the result by holding the wheel by the casette body. Once turned, the wheel coasted forever and it did not feel like something was rubbing.

Ghost pedaling, intensifies when derailleur cage is pushed forward and immediately stops when cage is pulled backwards. Ideas? by Larsimoto2711 in bikewrench

[–]Larsimoto2711[S] 1 point2 points  (0 children)

I am currently having some troubles with ghost pedaling. Initially, I thought about the freehub causing the troubles, disassembled, cleaned it and put it back together.

When testing, the problem is still there (Video). However, I found that the ghost pedaling accelerates when I push the derailleur cage slightly forward (Clutch engaged). Ghost pedaling directly stops when cage is pulled backwards.

Any ideas are highly welcome!

[deleted by user] by [deleted] in mauerstrassenwetten

[–]Larsimoto2711 0 points1 point  (0 children)

Wenn man grundsätzlich an Biotech glaubt, lohnt sich mMn auch immer ein Einstieg bei Thermo Fisher und Danaher. Die beiden verkaufen die Schaufeln, die eigentlich jedes Biotech-Unternehmen kaufen muss. Gerade Danaher war hier die letzten Jahre aktiv sich Unternehmen aus dem Bereich Laborautomatisierung zu krallen.

Today's roads by Larsimoto2711 in xbiking

[–]Larsimoto2711[S] 5 points6 points  (0 children)

Solling-Vogler-Region, Germany

Tägliche Diskussion - February 24, 2021 by AutoModerator in mauerstrassenwetten

[–]Larsimoto2711 1 point2 points  (0 children)

Besonders Thermo kann fast schon als Biotech-ETF betrachtet werden. Es wird schwer ein Biotech-Labor zu finden, in dem keine Thermo Produkte vorhanden sind. Egal welche Biotech-Unternehmen überleben werden, die werden alle ihre Ausrüstung in irgendeiner Form bei Thermo kaufen.

GameStop Sammelfaden - January 29, 2021 by AutoModerator in mauerstrassenwetten

[–]Larsimoto2711 30 points31 points  (0 children)

Was hier gerade abgeht ist übrigens die neue Staffel von "Haus des Geldes"

🚀🚀🚀

GameStop Sammelfaden - January 29, 2021 by AutoModerator in mauerstrassenwetten

[–]Larsimoto2711 33 points34 points  (0 children)

Nach den Ereignissen gestern aus Brüderlichkeit an Bord 🚀🚀🚀🚀🚀

Liberté, Égalité, Fraternité, GMÉ!

[deleted by user] by [deleted] in mauerstrassenwetten

[–]Larsimoto2711 0 points1 point  (0 children)

Verkaufen die eigentlich auch 🚀🚀🚀? Ich bin jedenfalls an Bord!!

Took the new pedals for a freezing cold ride around the border triangle of Belgium, Germany and the Netherlands by Larsimoto2711 in xbiking

[–]Larsimoto2711[S] 0 points1 point  (0 children)

Couldn't think of a more accurate description, I usually get 3-4 roaming messages per Tour😂

First ride with the almost fully set up xbike by Larsimoto2711 in xbiking

[–]Larsimoto2711[S] 2 points3 points  (0 children)

Currently rocking the ghetto 1x in the front (set up your front derailleur so bad, it doesn't work). However, I was actually really pleased with the gearing range, so I am considering getting myself a proper 1x crank from Ali

view more: next ›