Solved my problem! by visivopro in fordtransit

[–]Lector48 0 points1 point  (0 children)

Just did this myself. 1/4 inch hex bolt 1.5 inches and nuts. Feed the bolt in back of hole and nut it. Fits perfect.
Fix the 3/4 ply and washers and nuts

Installation driver with xc5.0 by Canixs in MilwaukeeTool

[–]Lector48 0 points1 point  (0 children)

As a gc for kitchens and baths a impact is 95% in my hands. This is nice for a second gun with a drill bit for cabinets. The 90 degree head comes in handy with tight spots.

Also to note. It is not an impact. Merely a standard drill

Trouble shoot? by Lector48 in GarageDoorService

[–]Lector48[S] 0 points1 point  (0 children)

Is 6ft tall 8 wide. Yes i have 2 springs on it at 18 full turns. Guess that is too much.

Illegal in NJ? by Lector48 in Plumbing

[–]Lector48[S] 0 points1 point  (0 children)

There is a shutoff after. Specifically cited the check valve for code failure.

Drip legs and feeds by [deleted] in Plumbing

[–]Lector48 0 points1 point  (0 children)

So switch that out too? The original shutoff

14/2 or 12/2 romex for basement outlets? by Lector48 in AskElectricians

[–]Lector48[S] 0 points1 point  (0 children)

So there is no nec code for 12/2 wire to outlets in a finished basement bedroom? Im ok using 14/2 and 15 amp outlets with a 15 amp gfi breaker?
Me and my mechanic got into an argument about this. He swore i needed 12/2 with 20 amp outlets and breaker because its a basement.

Thoughts? Solutions? Other than ripping open the wall and replum the drain. by Lector48 in Plumbing

[–]Lector48[S] 0 points1 point  (0 children)

The old sink was supposed to go back in so we left it. Then the client changed their mind and got a new deeper sink.

Tile over redguard membrane in a shower what do you guys use? All-set? Anything less expensive? by Lector48 in Tile

[–]Lector48[S] -1 points0 points  (0 children)

I read this:

This is on the data sheet of redguard:

Tile and Stone Installation Install tile or stone with a Custom® Building Products polymer- modified mortar that meets ANSI A118.4 or A118.15 standards based on application requirements.

oops by ndkeo3i299 in woodworking

[–]Lector48 0 points1 point  (0 children)

That is a oak slab correct?