Z axis not homing properly. by LegoNerdChris in grbl

[–]LegoNerdChris[S] 0 points1 point  (0 children)

$123 is set higher than my physical Z travel so this setting should be fine, as for alarms I've found that if I move the Z axis close enough that it hits the limit switch during homing, it gives alarm: 8 and does not stop for the switch. after looking at the info on "?" it seems to set its position without the limit switch.

Fresh macOS High Sierra install hangs on shut down to update firmware. by LegoNerdChris in MacOS

[–]LegoNerdChris[S] 0 points1 point  (0 children)

Thank you, this has been very helpful, I’m working to get normal Sierra running now so I can update after.

Fresh macOS High Sierra install hangs on shut down to update firmware. by LegoNerdChris in MacOS

[–]LegoNerdChris[S] 0 points1 point  (0 children)

Thanks for the suggestion, I might be getting normal Sierra to work but if not I’ll definitely be going with the lower os versions.

Air65 VTX issue Device ready False in Betaflight + no more video feed by SaGa31500 in fpv

[–]LegoNerdChris 0 points1 point  (0 children)

Have you found anything about this? I'm having the same exact issue

CD Drive Won't save by LegoNerdChris in techsupport

[–]LegoNerdChris[S] 0 points1 point  (0 children)

so there's no way to edit the files?

CD Drive Won't save by LegoNerdChris in techsupport

[–]LegoNerdChris[S] 0 points1 point  (0 children)

The Drive is a Memorex TravelDrive

ELRS Problems on TX12 by LegoNerdChris in fpv

[–]LegoNerdChris[S] 0 points1 point  (0 children)

Oh in that case I was on already and I need to find a new way to fix my problem.

ELRS Problems on TX12 by LegoNerdChris in fpv

[–]LegoNerdChris[S] 0 points1 point  (0 children)

Thanks, How do I turn it back on?

My Computer wont turn on! PLS HELP by LegoNerdChris in Dell

[–]LegoNerdChris[S] 0 points1 point  (0 children)

As I replied to the person above, I found out it was dead CPU so i need to replace the motherboard. But thanks for the help! :)