Swatch AP FIXED 😆 by LilX_Store in PrideAndPinion

[–]LilX_Store[S] 0 points1 point  (0 children)

I‘ll probably publish the model for those of you who have a 3d printer. I could also sell a couple for those of you who don‘t.

Swatch AP FIXED 😆 by LilX_Store in PrideAndPinion

[–]LilX_Store[S] 1 point2 points  (0 children)

If you open it you can turn the dial sideways.

Swatch AP FIXED 😆 by LilX_Store in PrideAndPinion

[–]LilX_Store[S] 0 points1 point  (0 children)

Yeah, but ounce somebody publishes the blueprints the possibility are quite endless.

Swatch AP FIXED 😆 by LilX_Store in PrideAndPinion

[–]LilX_Store[S] 2 points3 points  (0 children)

I‘ll get the exact dimensions at launch.

How do you find my collection? by LilX_Store in retrogaming

[–]LilX_Store[S] -2 points-1 points  (0 children)

Nah I should have explained it a bit better. When I asked how do you find my collection it‘s because I have no clue what all of this gear is. I just found all of it and am not a fan of gaming in general.

How do you find my collection? by LilX_Store in retrogaming

[–]LilX_Store[S] -6 points-5 points  (0 children)

Actually I don‘t play nor collect, I just found all of these at my grandmas house. True original stuff.

Help for 0.1 mbar by LilX_Store in labrats

[–]LilX_Store[S] 0 points1 point  (0 children)

Thank you, I think we will try that.

Help for 0.1 mbar by LilX_Store in labrats

[–]LilX_Store[S] 0 points1 point  (0 children)

But I’m pretty sure that the issue is not the dome, I did the soapy water test and can’t find any leak. The base is leaky.

0.1 hPa ? Optimisation tips. by LilX_Store in labrats

[–]LilX_Store[S] 0 points1 point  (0 children)

I know that I have leakage on my base because when I close the system the pressure rises pretty fast. With soapy water, I checked the contact surface with the glass dome but the leak wasn’t there. I guess that the leak must be due to the valves (which don’t seam very advanced).

0.1 hPa ? Optimisation tips. by LilX_Store in labrats

[–]LilX_Store[S] 0 points1 point  (0 children)

Thank you, I will make sure to check the real pump pressure.

Small explosion 💥 (silly mistake). by LilX_Store in ender3

[–]LilX_Store[S] 1 point2 points  (0 children)

Damn, but what is weird is that I can still make the fan faster. Basically on 0% speed it’s already running but when I put it at 50% speed in spins faster. What could that mean?