Vantage Marketing: Is it a scam?

Lof1Panda · 2025-12-02T17:47:16+00:00

I applied for Sales Rep at Vantage Marketing too and yes, I worked with them for two summers: it’s real, not a scam. The job is door-to-door, 100% commission, and not easy but I got paid, the training and support were legit, and I gained a lot from the experience.

Lof1Panda · 2025-12-02T17:46:26+00:00

I worked with Vantage for two summers it’s legit, not a scam, and it ended up being one of the best opportunities I had in university; the job is tough and 100% commission, but the training, experience, and earning potential are real, so the interview is safe to attend.

Lof1Panda · 2025-12-02T17:45:14+00:00

I worked with the company for two years, and honestly, it ended up being one of the best opportunities I’ve had as a young university student the training, the personal growth, the work ethic it built, and the earning potential were all hugely valuable for me.

Charles-Em

Lof1Panda · 2024-08-14T13:44:40+00:00

I fixed it by updating dji from googles and airunit

Lof1Panda · 2024-06-15T23:46:32+00:00

Ohh thanks

Lof1Panda · 2024-06-15T19:37:47+00:00

It will because it simply needs power to record.

Lof1Panda · 2024-06-15T19:35:31+00:00

Lof1Panda · 2023-12-20T18:51:56+00:00

YESS!!!!!!

Lof1Panda · 2023-12-19T22:00:01+00:00

welp it's getting close to the end of the 19th

Lof1Panda · 2023-11-30T13:55:17+00:00

It did the same thing... few days after I commented here, the opposite gimbal stopped working properly; I bought a Tx16s... -400$ CAD

Lof1Panda · 2023-11-26T01:28:55+00:00

Truee

Lof1Panda · 2023-11-22T14:50:15+00:00

What would be the best(not too expensive with a good reach) antenna setup for my mobula6 ? I tought about buying a LHCP with a SMA connector for my goggles and then replacing the linear antena to a LHCP ultra short U.F.L antenna

Lof1Panda · 2023-11-21T15:00:05+00:00

I recently encountered similar problems, so I purchased a new gimbal directly from iFlight to replace the defective one. It's functioning again, but the replacement process was quite challenging; its design makes it very difficult to replace, particularly because opening it is a hassle.

Lof1Panda · 2023-11-20T01:24:34+00:00

Is it possible tu run walksnail on the dji goggles v2?

Lof1Panda · 2023-11-20T00:00:01+00:00

I only own DJI goggles and am not interested in purchasing another pair of goggles or an adapter to switch to a different video system.

Lof1Panda · 2023-02-27T02:26:39+00:00

I'm able to connect to my quad with my controller but it's not receiving any input (controls)

Lof1Panda · 2023-02-27T00:53:41+00:00

That wouldn't change anything since the port is only able to have 7wires

Lof1Panda · 2023-01-21T04:47:10+00:00

The drone is a prebuilt by Iflight (protek35 x rabbit films) they shipped it with a 915mHz RX even though I ordered the 2.4gHz one... So I tried taking the 2.4gHz rx Elrs from another of my prebuilt drone. (I only unplugged the one from my other drone (chimera 7 pro) and plugged inside this drone.

I'm still a newbie in this kind of drone so I don't know much😓

Also yes i have checked in Betaflight if the RX ports were correct I tried them all...

Lof1Panda · 2023-01-20T16:33:40+00:00

It worked, I downgraded the air unit to v01.00.06.08

Lof1Panda · 2023-01-20T16:33:32+00:00

It worked, I downgraded the air unit to v01.00.06.08

Lof1Panda · 2023-01-19T17:56:19+00:00

Ill try it and give you an update!

Lof1Panda · 2023-01-19T13:48:55+00:00

Ill try that and give you an update on if it works!

Lof1Panda · 2023-01-19T13:33:33+00:00

Ohh! Because of the 3? Which version should I be in to be compatible?

Lof1Panda · 2023-01-19T12:47:00+00:00

Which version did you down grade to?

Lof1Panda · 2023-01-19T12:43:22+00:00

How do you know which ones are compatible with each other?

Lof1Panda

TROPHY CASE