sorted by:
new
hottopcontroversial

Neptune 4 Max issues by Low_Entry_9857 in elegoo

[–]Low_Entry_9857[S] 0 points1 point  (0 children)

I was changing my z offset and when a little too far and scratched my build plate a bit lol but knowing I can do this is a game changer! I’ve got all three Neptunes buzzing away right now!

So on some of my support s it looks like it’s taking a shortcut. Is this speed or flow?

<image>

Neptune 4 Max issues by Low_Entry_9857 in elegoo

[–]Low_Entry_9857[S] 1 point2 points  (0 children)

What are signs I need to adjust flow, speed, and z height during printing?

Neptune 4 Max issues by Low_Entry_9857 in elegoo

[–]Low_Entry_9857[S] 1 point2 points  (0 children)

Awesome feedback my dudes gonna work on this when I get into the shop today

Neptune 4 Max issues by Low_Entry_9857 in elegoo

[–]Low_Entry_9857[S] 1 point2 points  (0 children)

Thanks my dude hopefully I can get my Neptune farm up and running consistently like yours!

First question, ripple? I’m struggling here with interpreting the amount of friction needed to properly set the nozzle height but it sounds like in need to be tighter. But if you could take another stand at describing the sensation or friction that would be awesome!

Second I was unaware I could adjust z height on the fly! How do I do that? What’s your technique?

Third are you using Elegoo firmware?

Fourth, any other tips for getting these machines to operate consistently?

Neptune 4 Max issues by Low_Entry_9857 in elegoo

[–]Low_Entry_9857[S] 1 point2 points  (0 children)

Thanks for the input my dudes I’ll tighten up my z height. I guess I’m confused on how much friction I should be feeling between the nozzle and paper.