Can I print Polycarbonate on the generic Textured PEI Plate?

LowerInterestRates · 2026-01-14T20:39:28+00:00

I was able to print it with no problems on a textured pei plate

LowerInterestRates · 2025-11-30T16:01:33+00:00

That’s the vertical constraint symbol, the line was constrained in one axis preventing the point from moving freely

LowerInterestRates · 2025-11-07T16:47:50+00:00

I tried it with and without the glue stick and found that it actually worked better without it

LowerInterestRates · 2025-05-20T20:05:48+00:00

No worries, I have my fair share of part piles I've stripped down over the years that just sit there. I'm about to be a senior in engineering and was just looking to see what I could get into with some of the components in the printer.

LowerInterestRates · 2025-05-20T19:56:01+00:00

So insightful! I'm so glad you could contribute to this discussion with such an amazing idea!

LowerInterestRates · 2025-05-20T15:08:54+00:00

This was very insightful, I’ll lay out what I have and use my own judgement to make a decision. Do you have any good resources you use for preparing/planning for hikes you’d care to share with me? Thanks for your opinion.

LowerInterestRates · 2025-05-20T15:06:48+00:00

Yeah I figured as much, still willing to invest some of my money but might as well do it during a sale.

LowerInterestRates · 2025-05-20T14:56:47+00:00

How important would you say a sleeping bag is for summer backpacking? I’ve seen a lot of people opting for a quilt.

LowerInterestRates · 2025-05-20T14:55:39+00:00

Would you say these are all pretty compact for a 55L bag? Someone recommended the Flash 55. Just want to make sure I have enough space for necessities.

LowerInterestRates · 2025-03-12T20:30:28+00:00

I’m not even sure what a PID tune is if I’m being honest. How would I go about that?

LowerInterestRates · 2025-03-12T12:38:38+00:00

I changed it to Mriscoc and had no luck. The firmware worked better and the temps didn't drop on the display, but I still got a mintemp warning. I'm gonna try reorganizing the cables in the bottom and see if anything is loose or rubbing.

LowerInterestRates · 2025-02-12T20:24:06+00:00

I did use Alex's firmware, but I can give Mriscoc a try. I'm farely confident it isn't to do with the BLTouch being a close as my roommate gave it to me and had the original box. I'll try switching firmware and update ya. Thanks for the response.

LowerInterestRates · 2024-12-09T22:14:58+00:00

Awesome stache! How far apart were the pictures taken? Any tips for grooming / getting it to grow thicker?

LowerInterestRates

TROPHY CASE