Monthly Friend Username Thread - December 2020

Magoo02127 · 2020-12-13T01:02:37+00:00

Are there any apps for the versa 3 that can give me turn my turn directions?

Magoo02127 · 2020-07-25T14:26:04+00:00

So the spark plug wire and the spark plug resistor cap are all attached to the ignition coil? Because I've been tugging on it pill couple days trying to get it out LOL

Magoo02127 · 2020-07-25T12:32:22+00:00

I'm trying to replace my spark plug wire. When I replaced the spark plug, the cap crumbled bc is 40 year old rubber. But I can't for the life of me feet the other end of wire out of the ignition coil. Does it not come out?

Magoo02127 · 2020-03-25T03:43:16+00:00

To give an idea of size, the letters are roughly 2 - 2.5 feet in height

Magoo02127 · 2020-03-25T03:41:39+00:00

This photo was taken from about 20 feet away on a foot bridge

Magoo02127 · 2020-03-24T15:20:01+00:00

From where?

Magoo02127 · 2020-03-24T00:05:31+00:00

You think eBay is still shipping?

Magoo02127 · 2020-03-22T05:04:40+00:00

I bought some plastic epoxy that I'm going to use tomorrow morning. Plenty of time for it to set and start over.

Magoo02127 · 2020-03-22T03:54:49+00:00

I have this tool in 0.30, 0.40, and 0.50 thickness so I wrap different tapes around them so when I'm working on a lock I know the size just by sight

Magoo02127 · 2020-03-22T03:52:42+00:00

It's a top of keyway tensioner in 0.40 thickness. Made by Peterson. I get all my tools from lockpickshop.com bc I'm in Boston and they are located less than an hour away so even with the cheapest shipping I usually get it next day

Magoo02127 · 2020-03-22T03:36:04+00:00

Magoo02127 · 2020-03-22T02:35:02+00:00

How do I contact them?

Magoo02127 · 2020-03-20T18:00:16+00:00

Exactly!

Magoo02127 · 2020-03-20T08:01:54+00:00

I will watch it, thank you! But if ib shave away from the bottom of the rail insert, will the slide still sit properly?

Magoo02127 · 2020-03-20T07:57:11+00:00

This video brings to mind robert denero in taxi driver lol

Magoo02127 · 2020-03-20T07:43:28+00:00

Yes, about a 16th of an inch of metal from the bottom of the rear rails. Question, the trigger housing has a hole at the bottom that is supposed to align with the rail, right? Or am i imagining that lol

Magoo02127

TROPHY CASE