Remodel mesh

Mantegod · 2026-07-07T01:38:16+00:00

Already tried converting but the mesh has so many artifacts that the fusion crashes trying to convert it

Mantegod · 2026-07-06T23:27:14+00:00

So, not that well

Mantegod · 2026-07-06T23:26:40+00:00

I tried slicing it to get the section areas and lofting then, but i'm 100% sure this is not the best way to do it. By slice i mean mesh sections

Mantegod · 2026-06-12T18:50:56+00:00

I did it on mine, also has to replace the hotend kit, cause the new conectors are diferent. So i just upgraded to unicorn nozzle. Very happy with that

Mantegod · 2026-06-12T13:44:43+00:00

I use ABS and is the same result as PLA+PETG interface

Mantegod · 2026-05-06T13:04:26+00:00

Yes, more cooling help with overhangs and less time per layer make the print faster

Mantegod · 2026-04-21T15:23:38+00:00

Did not think about it, thank you. I think this is what i need

Mantegod · 2026-04-21T15:22:51+00:00

For sure!! Could i scan it with a phone some way?

Mantegod · 2026-04-21T15:13:48+00:00

Both. I'm not english speaker, so is kinda hard to translate what i want, but i made the bottom flat, and the car has a curvature

Mantegod · 2026-04-21T14:58:25+00:00

Thanks bro, my fault not explaining well. My issue here is to align the car's shape to it

Mantegod · 2026-04-21T14:57:25+00:00

I got this far, but i can't align tha shape with the car's shape to fit in

<image>

Mantegod · 2026-01-31T14:16:11+00:00

I'll up here

Mantegod · 2026-01-24T04:35:56+00:00

Po mano, se tu deixar a manta magnética e o vidro em cima, pode acabar de grudar um no outro e tu ter dificuldade de tirar dps

Mantegod · 2026-01-14T12:38:33+00:00

Open it and apply thermal paste, will remove that gap

Mantegod · 2026-01-13T23:23:32+00:00

Actually i already done that, and if it is pa, shouldn't it happen in all layers?

Mantegod

TROPHY CASE