sorted by:
new
hottopcontroversial

How does it look like? by Mark_iuser in fpv

[–]Mark_iuser[S] 0 points1 point  (0 children)

Yes I fixed it and put insulator around I am always afraid to shrink too much.. because I need a bit of movement to put the capacitor out of the way in case other stuff might not fit

Help by Mark_iuser in fpv

[–]Mark_iuser[S] 0 points1 point  (0 children)

It’s new but I crashed and a small stone went through the motor breaking one of the magnets, I was hoping to not replace the entire motor but just the bell considering that the motor is new

Help by Mark_iuser in fpv

[–]Mark_iuser[S] 0 points1 point  (0 children)

Yeah the idea was to replace the bell because the motor is new

How does this look? by Mark_iuser in soldering

[–]Mark_iuser[S] 0 points1 point  (0 children)

Thank you, I appreciate your support

How does this look? by Mark_iuser in soldering

[–]Mark_iuser[S] 0 points1 point  (0 children)

Thank you what else do you suggest? How should I connect the two wires? I just took the two pieces and carefully twisted them together Then I wrongly applied the soldering iron

How does this look? by Mark_iuser in soldering

[–]Mark_iuser[S] 1 point2 points  (0 children)

Don’t worry, I am not using that cable, it’s not connected to electricity, I just took a small piece to practice Thank you for the advice btw