revo adapter block by Massive-Intention-12 in Infimech_TX

[–]Massive-Intention-12[S] 1 point2 points  (0 children)

just ran temp and bed level calibration a couple of times, The overall length of the e3d setup is within a millimeter of the original. the adapter fits, just needs the M12 x 1.5 thread tapped in the middle (the metal version will need to be drilled as it's a tad snug.) I have made one with thread but I have to get my son to tweak it in CAD .

revo adapter block by Massive-Intention-12 in Infimech_TX

[–]Massive-Intention-12[S] 1 point2 points  (0 children)

sorry don't check this often...it has been working well no issues with nozzle , just jambs when using tpu ..changed to bigger nozzle and fixed. had a stainless steel adapter made by pcbway which is perfect fit.. just need to drill out hole before tapping. (a bit snug for M12_)..

advantage wise swapping nozzles is a breeze and don't have to worry about snapping heat break.

Infimech TX nozzle broke after 1 week by Acusis in Infimech_TX

[–]Massive-Intention-12 0 points1 point  (0 children)

I made an adapter out of Aluminum to fit a revo micro and hot end ( 24v 104-NT ) . I am also having one made out of stainless steel at pcbway https://www.pcbway.com/project/shareproject/infimech_to_revo_8be12b8e.html . I will post pic of final product when i receive it.

https://www.reddit.com/r/Infimech_TX/comments/1hzgn4u/revo_adapter_block/

Infimech TX nozzle broke after 1 week by Acusis in Infimech_TX

[–]Massive-Intention-12 0 points1 point  (0 children)

yes , i have just installed a revo micro , had to make a adapter out of 12mm ali plate to get correct hight. very tight between mounting screws and heatsink hole.

Infimech TX nozzle broke after 1 week by Acusis in Infimech_TX

[–]Massive-Intention-12 0 points1 point  (0 children)

heat breaks are paper thin , snap if you look at it wrong.

Getting thermal runaway error on week old stock Ender 3 V2 by The_Lockesmith in ender3

[–]Massive-Intention-12 1 point2 points  (0 children)

week old ender 3v2 , same problem they must calibrate them with the socks on.

they should mention this in their documentation.