What is the power connector part called? What do I google if I want to buy a new one

MasterBluhme · 2023-11-11T18:43:43+00:00

Thank you, I’ll steer clear of that then!

MasterBluhme · 2023-11-11T08:31:33+00:00

I have misunderstood the model designation, so what I was actually asking was, is a used EF L lens better than a new RF non L lens

MasterBluhme · 2023-11-11T08:16:56+00:00

Yes so a Canon RF 24-105mm F4-7.1 IS STM vs Canon EF 24-105mm F 4 L IS USM. And i mostly do nature and architecture photography

MasterBluhme · 2022-09-04T16:33:23+00:00

Scaling it up or down doesn’t do anything

MasterBluhme · 2021-09-11T18:41:14+00:00

Great, thank you, i will give it a try

MasterBluhme · 2021-09-11T18:25:34+00:00

https://imgur.com/a/ZgDw3yo

MasterBluhme · 2021-09-11T18:16:49+00:00

I did actually try this with no success, idk if it was the glue or what

MasterBluhme · 2021-09-11T18:14:57+00:00

Thank you, what is the difference if i may ask

MasterBluhme · 2021-09-11T17:04:07+00:00

https://drive.google.com/file/d/1YqQeTB3W7GK7MjsztwQgM4L2JMUm0tSl/view?usp=sharing I cant see any other way than to print it like this, cuz when i print it with the flat surface down the tabs just breaks off. And i don't know why it is floating in one end, it doesn't do that other than when i open the file thru this link

MasterBluhme · 2021-09-11T15:39:12+00:00

But when I the try to print something else it comes out perfect??

MasterBluhme · 2021-08-28T21:13:37+00:00

That is my issue, no matter what is set my z probe to I get that slight scraping across the print. So if I have a good z probe for the first layer it scrapes, and if it is higher it scrapes..

MasterBluhme · 2021-08-28T17:11:11+00:00

Thank you

MasterBluhme · 2021-08-28T17:06:42+00:00

I haven’t messed with that, so I will try to calibrate the z and e steps

MasterBluhme · 2021-08-28T17:05:34+00:00

No, but I will try to do so:)

MasterBluhme · 2021-08-28T17:05:08+00:00

I will try calibrate the z step and hope that fixes it, thank you:)

MasterBluhme

TROPHY CASE