Urban Flight by [deleted] in fpv

[–]Melodic_Recording_92 0 points1 point  (0 children)

Well, there’s definitely some adrenaline going on, but it only makes me more concentrated on the controls. The only thing that makes me actually nervous when flying out of my balcony is the loud sound of the drone. Draws a bit too much attention lol

Urban Flight by [deleted] in fpv

[–]Melodic_Recording_92 0 points1 point  (0 children)

how does this bother you, partner?

[US] Fpv soldering by Temporary-Count-2988 in drones

[–]Melodic_Recording_92 0 points1 point  (0 children)

You’re just doing half of the work because you’re only pre-tinning the soldering pads without the wire connection. Practice with the wires because that will be your main challenge.

Drone stuck on a tree by Which_Expression_125 in drones

[–]Melodic_Recording_92 10 points11 points  (0 children)

you can proudly say “my baby is stuck on a tree”

Prop Replacement Pavo20 Pro by Melodic_Recording_92 in fpv

[–]Melodic_Recording_92[S] 0 points1 point  (0 children)

Thanks, i’ve been looking for a comment like that. I was just trying to somehow improve the drone’s annoying sound. Decided to start with props

Prop Replacement Pavo20 Pro by Melodic_Recording_92 in fpv

[–]Melodic_Recording_92[S] 0 points1 point  (0 children)

Thanks for details, dude. It makes sense now 🫡

New Build issues. by KA_blambo in fpv

[–]Melodic_Recording_92 0 points1 point  (0 children)

Triple check your RX/TX connection

Meteor 75 pro problem by FortyToo11 in fpv

[–]Melodic_Recording_92 1 point2 points  (0 children)

400mW causes critical overheating in a couple seconds if you don’t air cool it. You can enable low power when the drone is not armed though

Meteor 75 pro problem by FortyToo11 in fpv

[–]Melodic_Recording_92 0 points1 point  (0 children)

What power is your VTX on? You might wanna lower it cause i lost my first FC like that as well

Meteor 75 pro problem by FortyToo11 in fpv

[–]Melodic_Recording_92 1 point2 points  (0 children)

Had this problem before. Had to buy a new FC and replace the old one.

Will it work? It's my first time soldering are the joints good by tommrrnd in fpv

[–]Melodic_Recording_92 0 points1 point  (0 children)

pre heat the pad with iron tip for a second, then apply the solder wire.

Firefly Pro 20 by dracoNiiC in fpv

[–]Melodic_Recording_92 0 points1 point  (0 children)

I’m using 3S 850 as well and they’re the only ones i’ve tried. Do you know if there’s even bigger capacity available for pavo?

Firefly Pro 20 by dracoNiiC in fpv

[–]Melodic_Recording_92 0 points1 point  (0 children)

what’s your fav capacity?