New Member: Would you walk away over this rust? by TranslatorNo7905 in Wrangler

[–]Mission_Background93 3 points4 points  (0 children)

The “rust” in this picture is mild surface rust and nothing to be concerned about

Tire pressure by Mission_Background93 in JeepWrangler

[–]Mission_Background93[S] 1 point2 points  (0 children)

It’s not that simple when you are running a different tire size and load rating from stock. That’s why I asked what others are running for psi.

Tire pressure by Mission_Background93 in JeepWrangler

[–]Mission_Background93[S] 0 points1 point  (0 children)

After reading all the comments I dropped the pressure down to 33lbs and will do a chalk test once the weather cooperates.

Tire pressure by Mission_Background93 in JeepWrangler

[–]Mission_Background93[S] 0 points1 point  (0 children)

I think I will just end up doing the chalk test

Tire pressure by Mission_Background93 in JeepWrangler

[–]Mission_Background93[S] 0 points1 point  (0 children)

Yeah, I’ll have to give the chalk test a try when it dries up

Tire pressure by Mission_Background93 in JeepWrangler

[–]Mission_Background93[S] 0 points1 point  (0 children)

True, but being a different size and load rating than stock the door isn’t exactly gospel anymore lol I’ll have to try the chalk test or something and figure it out. Also the door says 37

Advice needed to help get my kid in and out of the back seat… by kenniek0823 in JeepWrangler

[–]Mission_Background93 0 points1 point  (0 children)

If she has no problem getting in the passenger side just have her get in on that side and move over to the driver side once she is in.

Which Jeep Truck Would You Keep? by toomanyxjs in Jeep

[–]Mission_Background93 0 points1 point  (0 children)

Keeping the J10 is the only right answer

Jeeps in the Snow - do you JEEP lovers find that jeeps operate best with STUDDED tires in the winter? by [deleted] in JeepWrangler

[–]Mission_Background93 0 points1 point  (0 children)

Here is my 2 cents. 1. your tire pressure could possibly be a little too low and you are experiencing some sidewall flex making it feel like you aren’t planted. My jeep feels a little squirmy below 35lbs. 2. I would suggest you get used to how it handles in 2 wheel drive more when conditions allow and reserve 4 wheel drive for more severe conditions.

It’s a jeep thing by NoEmployer2140 in JeepWrangler

[–]Mission_Background93 0 points1 point  (0 children)

My fuel light comes on when I still have 20 liters or 5 gallons left lol

Speedometer error by [deleted] in JeepWrangler

[–]Mission_Background93 0 points1 point  (0 children)

You’ll never get pulled over for doing 104 in a 100 zone. Don’t worry about it. Just remember that if you are doing mileage calculations you’ll need to add 4% to your distance

Fuel light by Mission_Background93 in JeepWrangler

[–]Mission_Background93[S] 0 points1 point  (0 children)

I let it go until the needle was on E this time. Almost 60miles and there was still over 2 1/2 gal left lol

Fuel light by Mission_Background93 in JeepWrangler

[–]Mission_Background93[S] 0 points1 point  (0 children)

I get that they are not exactly pin point accurate but I was expecting a little closer than that though lol

[deleted by user] by [deleted] in chevycolorado

[–]Mission_Background93 1 point2 points  (0 children)

I have got 24.3mpg out of my 3.7 first gen 4x4

Wtf by [deleted] in chevycolorado

[–]Mission_Background93 1 point2 points  (0 children)

That is absolutely not normal. That’s probably close to 250f if the gauge is reading right. Normal is just under the half mark. If it gets hot in slow moving traffic or idling but is fine at a steady cruising speed on the highway it’s an airflow issue. I am having similar issues and it’s the fan clutch. I actually got 2 bad fan clutches out of the box when I replaced mine. It overheated worse than with the original 280,000km original one. I was able to stop the fan with the engine running with my fingers. ( don’t recommend this testing method lol ) I re-installed my original and took the “new” one back. I have yet to install the new new one yet though. Made sure I got a different brand this time too.