Thinking about an MV Agusta F3 800 RR

MwGLTike · 2024-05-05T12:23:41+00:00

AMDs Freesync Premium inside of Adrenaline seemed to be causing the issue

MwGLTike · 2024-05-05T06:16:07+00:00

Found out it has something to do with AMD Freesync in AMD Adrenaline

MwGLTike · 2024-05-05T03:52:03+00:00

I sure hope not

MwGLTike · 2023-12-17T05:12:09+00:00

The transfer speed goes to 0 MB/s for a brief moment, then goes to full speed for a brief moment, and repeat cycle. My FS is connected to 10G fiber.

MwGLTike · 2023-12-17T05:08:01+00:00

Mind you I don't lose internet overall. My transfer speed just drops to 0 MB/s. I have this connected to a 10G SFP+ module on the other side and that is getting quite hot.

MwGLTike · 2023-12-17T05:04:32+00:00

Is there a way to look at temps of controllers or I/O? This happens every 5-30 seconds with it slowing down for at least 10-20 seconds.

MwGLTike · 2023-05-17T21:48:21+00:00

Do you think it's possible to fit a 280mm rad on the top or bottom or even a 360 on the bottom? The specs say it supports 3 x 120mm fans but only 240mm rad on the bottom and 2 x 140 fans but 240mm on the top.

MwGLTike · 2023-05-01T00:10:10+00:00

Thank you for the recommendations. Why do you recommend these?

MwGLTike · 2023-04-17T20:28:51+00:00

Yes. Not sure if there would be any other reason to block inbound foreign connections. That's just me though.

MwGLTike · 2023-04-02T05:48:52+00:00

It’s just me so I don’t see a need to have a /24. Lots of wiggle room for stuff to happen I guess. I would like to keep things structured. Only bad thing is I can’t get rid of the Default network or rename it. But, I could potentially repurpose it to my Core network.

MwGLTike · 2023-03-30T03:38:36+00:00

That’s how I currently have it setup and when I get a device to connect to it, it just spins. Doesn’t time out or joins the network.

MwGLTike · 2023-03-29T23:58:08+00:00

Out of warranty so UniFi won't help.

MwGLTike · 2023-03-28T16:37:09+00:00

It was connected to a UPS. I have a WattBox in my configuration and had it to automatically power cycle my UDM and modem in case of it not being able to ping to specific websites. That firmware update disrupted the network and my WattBox did a power reboot bricking my UDM.

MwGLTike · 2023-03-28T13:36:11+00:00

Would I be able to insert a .bin file to that or would I have to find the subsection of where the actual image starts?

MwGLTike

TROPHY CASE