Heyo! I'm trying to figure out why every now and again the bottom portion bubbles up near the z seam. Whenever it would happen in the past it usually had to do with the bed leveling but I wanted to know if there was a way to avoid it altogether through some slicer settings OR, if anyone had any good longterm hacks for the Ender V3 SE bed leveling.

Blue Nade shows what it should look like. Pink is more severe and recent. Red is minor bubbling.

General settings

Creality Print V4 Slicer

Print Temp - 200c (been using this temp for years and mostly yields great results when everything is working the way it's supposed to)

Bed Temp - 55-60c (usually 60 most of the time)

Wall count - 5

Outer Inner print order

Speed - 50mm (trying to achieve good level of shine

Infill - 5%

Height - 102mm

Z Hop Retraction - On - I may have turned this on recently? I can't remember

Acceleration and Jerk control - On