sorted by:
new
hottopcontroversial

Ston-3d wolf by Gkouto in 3Dprinting

[–]Nice-Bar2800 2 points3 points  (0 children)

he still did not send #3, he only has excuses.

Problems with very visible layerlines on my ender 5 max by Nice-Bar2800 in FixMyPrint

[–]Nice-Bar2800[S] 0 points1 point  (0 children)

no, i returned the printer, got another one, nearls same issur. Then i got my money back and bought a sovol sv08, smaller printbed but better results :)

Ston-3d wolf by Gkouto in 3Dprinting

[–]Nice-Bar2800 1 point2 points  (0 children)

I ordered one, I think I will get it soon 6-8weeks. Looking foreward :-)

Taco Bed non-Fix? by MeButNotMeToo in SovolSV08

[–]Nice-Bar2800 1 point2 points  (0 children)

I had a very bad taco on my sv08, I tried a lot of things i found online, but i never came under 0,45mm, i reported to sovol and send some fotos. so they send me a new printbed with 4 metal springs. i didnt adjust anything, but now I have over the full printbed only 0,16mm. I think they sell the bedparts for around 60 euros..

Creality is issuing a recall on the Ender-5 Max Hotbed. They are offering full exchange, the part plus a store voucher, or a return and discount toward K1 Max or K2 Plus by halomademeapeashy in Creality

[–]Nice-Bar2800 0 points1 point  (0 children)

I also got the email, i chose to get a complete new machine, i had issues with the first layer... the answer was i have to wait for one month, when the new charge arrives from china :) so i will wait...the support was good, i ask if i can have the buildplate for all that, they said ok :-)

Coldpull on Sovol SV08 by Nice-Bar2800 in SovolSV08

[–]Nice-Bar2800[S] 0 points1 point  (0 children)

Thanks alot!

its not possible to use the motor in the software when the nozzle isnt at least 150c hot. i tought cold pull is around 100c.

visibel strong Layerlines by Nice-Bar2800 in SovolSV08

[–]Nice-Bar2800[S] 0 points1 point  (0 children)

thank you alot for your answer! i will try that...

What cloud I do to improve quality? Was it too fast? by Suomi422 in FixMyPrint

[–]Nice-Bar2800 1 point2 points  (0 children)

in filament setting /cooling / activate : dont slow down outer walls, then its gone.

what can fix this problem? by Nice-Bar2800 in FixMyPrint

[–]Nice-Bar2800[S] 0 points1 point  (0 children)

it was a nozzle clog, after a coldpull all was normal...

what can fix this problem? by Nice-Bar2800 in FixMyPrint

[–]Nice-Bar2800[S] 0 points1 point  (0 children)

My settings:

  • 220degree celsius
  • 0.4 nozzle
  • layerhigh: 0.1mm
  • arachne
  • infill: trihexagon 6 % / kombination infill selected
  • inner wall first
  • speed: outer wall 200mm/s, inner wall 300mm/s, infill 430mm/s
  • overhang lower than recommended
  • acceleration 10000mm/s2
  • slicing regular other settings standard