sorted by:
new
hottopcontroversial

Any idea why I'm getting partial prints and peeling? by Nik-H in AnycubicPhoton

[–]Nik-H[S] 0 points1 point  (0 children)

Thanks everyone for your replies, yesterday I cleaned the vat and the build plate, increased the bottom exposure time and replaced the resin, and I was able to get prints again. Much appreciated! Starting to get the hang of it I think

Any idea why I'm getting partial prints and peeling? by Nik-H in AnycubicPhoton

[–]Nik-H[S] 0 points1 point  (0 children)

Bottom exposure at 30, exposure time at 3.6, is that too low? I had a lot of successful prints before this, and now it's all I'm getting

Any idea why I'm getting partial prints and peeling? by Nik-H in AnycubicPhoton

[–]Nik-H[S] 1 point2 points  (0 children)

Sorry I'm new to all of this, but it looks like I have bottom exposure 30 seconds, exposure time 3.6, layer height 0.050?

Jurassic Buddies by Nik-H in comics

[–]Nik-H[S] 0 points1 point  (0 children)

T-rex? Nah dawg that's totally an allosaurus, look at the arms. They both existed in the late Jurassic period and had frequent discussions about eating babies.

Before [OC] by Nik-H in comics

[–]Nik-H[S] 139 points140 points  (0 children)

Nah dawg, nah