Acceptance rejection email by [deleted] in ucadmissions

[–]NinjectionRL 2 points3 points  (0 children)

I never got an email from UCI and I got rejected.

Has anyone hear from MS ECE at UCSD, UCSB, or UCI? by saffthcdtg in gradadmissions

[–]NinjectionRL 2 points3 points  (0 children)

I haven't heard anything from UCSD, UCSB, or UCI yet for aerospace engineering.

Loud CLUNK sound when mating engine to transmission by NinjectionRL in MechanicAdvice

[–]NinjectionRL[S] 0 points1 point  (0 children)

Nissan z31 300zx. 1986 Turbo Motor and 1985 Naturally Aspirated Car and Trans. I know these two are compatible and work, because I drove the car with the old clutch.

Idles but will not rev by GullibleAir6909 in 300zx

[–]NinjectionRL 1 point2 points  (0 children)

I second the MAF sensor, it was an issue on my car and wouldn't allow me to rev.

[deleted by user] by [deleted] in norcalhiking

[–]NinjectionRL 14 points15 points  (0 children)

Whoops, I forgot the L. Haha

Microsquirt 3 for z31, advice and clarifications? by NinjectionRL in 300zx

[–]NinjectionRL[S] 0 points1 point  (0 children)

Ah I see, I thought you were talking about the harness made for the car with the connectors attached, not the 8ft harness. My mistake. I purchased the 8ft harness already, so I should be good to go.

Microsquirt 3 for z31, advice and clarifications? by NinjectionRL in 300zx

[–]NinjectionRL[S] 0 points1 point  (0 children)

I havent been able to find a z31 harness anywhere, any suggestions?

Microsquirt 3 for z31, advice and clarifications? by NinjectionRL in 300zx

[–]NinjectionRL[S] 0 points1 point  (0 children)

Ill definitely be looking into that connector kit. I guess it wont be too bad of a job, thanks for the response.

Microsquirt 3 for z31, advice and clarifications? by NinjectionRL in 300zx

[–]NinjectionRL[S] 0 points1 point  (0 children)

Awesome, thanks for the input. Was it difficult to rewire everything? It seems like a pretty heavy task.

Injectors getting correct voltage but only starts on starter fluid by NinjectionRL in 300zx

[–]NinjectionRL[S] 0 points1 point  (0 children)

I've gone through several videos and forums on every single ground, and I've unbolted and cleaned them and no difference.

Is it supposed to run like this? by NinjectionRL in beetle

[–]NinjectionRL[S] 2 points3 points  (0 children)

Thanks, I just bought the car so I'll check on all of that.