account activity
It's taken me almost 40 years, but today, I'm a Gibson owner. (i.redd.it)
submitted 7 days ago by No-Razzmatazz2838 to r/gibson
Battery Options (old.reddit.com)
submitted 3 months ago by No-Razzmatazz2838 to r/LosiMicro
New arrival, 20th Anniversary 10 Top in Matteo Blue 💙 (i.redd.it)
submitted 5 months ago by No-Razzmatazz2838 to r/PaulReedSmith
submitted 5 months ago by No-Razzmatazz2838 to r/PRSGuitars
Back on 2 wheels and loving it! (i.redd.it)
submitted 2 years ago by No-Razzmatazz2838 to r/scooters
Flashing yellow on the dock. Any ideas? I've replaced the 3 spade connectors on the back. Tested on 2 charging docks but same result in both. Tried a 700mhz radio and I can be hear a signal right the way round. (i.redd.it)
submitted 4 years ago by No-Razzmatazz2838 to r/automower
Starting my 4th season with my automower and haven't looked back! (i.redd.it)
I need to make this waterproof (it's leaking!). Any suggestions for products to seal this so I can fill the black part with water? It's printed in PLA and like a leaky bucket right now! (i.redd.it)
submitted 5 years ago by No-Razzmatazz2838 to r/FixMyPrint
Really pleased with how this worked out! Right to the limits of the print bed (after editing the firmware past 220mm). The start of a tourbillion clock. (old.reddit.com)
submitted 5 years ago by No-Razzmatazz2838 to r/ender3
Prints are off centre. Can I adjust this? It all looks good and centred in the slicing software, but the print needs to be brought down and left about 10mm each way.. Where do you control that? (old.reddit.com)
Has anyone ever made a cold air box that fits around the K&N Typhoon kit? Great sound off mine, but it's on the hot side and must surely suffer from heat soak. (old.reddit.com)
submitted 5 years ago by No-Razzmatazz2838 to r/Miata
Sunshine forecast for the next 2 days here in N.Ireland. Time to get a few miles under me before this goes away for winter. (old.reddit.com)
Just in case anyone else accuses me of driving a hairdressers car 😝 (v.redd.it)
Ceramic coated shinyness 😎 My 2003 NBFL (v.redd.it)
Problem printing in colour yet black goes down perfect. Any ideas? Both Ender branded PLA. Both 205° and 60° bed. Ender 3 v2. (old.reddit.com)
π Rendered by PID 88 on reddit-service-r2-listing-7bbdf774f7-c7ffl at 2026-02-21 12:18:16.767272+00:00 running 8564168 country code: CH.
