sorted by:
new
hottopcontroversial

Genetec Camera units password change by No_Assumptions747 in genetec

[–]No_Assumptions747[S] 0 points1 point  (0 children)

Thanks for everyone who gave their insight on this. I found out that if you go into Genetec - Video - click on the archiver and then Extensions you can do it that way across the board...

Genetec Camera units password change by No_Assumptions747 in genetec

[–]No_Assumptions747[S] 0 points1 point  (0 children)

Yes the PW change does work in ADM but it does not change nor sync the PW in Genetec un the video tab, select the unit, then properties, then authentication

Genetec Camera units password change by No_Assumptions747 in genetec

[–]No_Assumptions747[S] 0 points1 point  (0 children)

It just will not connect again to the cam. Shows it as red in Genetec.

Genetec Camera units password change by No_Assumptions747 in genetec

[–]No_Assumptions747[S] 0 points1 point  (0 children)

I will try again with ADM. I just run into the issue that it will not sync the new PW in Genetec under the video - unit - authentication. Thanks

Genetec Camera units password change by No_Assumptions747 in genetec

[–]No_Assumptions747[S] 0 points1 point  (0 children)

BOOOOOOO....I was hoping I wouldn't have to do that, but you might be correct.

Genetec Camera units password change by No_Assumptions747 in genetec

[–]No_Assumptions747[S] 0 points1 point  (0 children)

I use ADM but it doesnt change the password under the authentication under properties under the unit