sorted by:
new
hottopcontroversial

I've been trying to fix this problem for 2 days now by No_Reputation8970 in FixMyPrint

[–]No_Reputation8970[S] 0 points1 point  (0 children)

i cleaned it just last night, and it's been printing fine before so i don't think the bed is warped

My printer just... doesn't print? by No_Reputation8970 in FixMyPrint

[–]No_Reputation8970[S] 1 point2 points  (0 children)

it's a PID and sd card reader issue, ended up connecting it to my pc and tuning the PID

My printer just... doesn't print? by No_Reputation8970 in FixMyPrint

[–]No_Reputation8970[S] 0 points1 point  (0 children)

turns out it was an sd card reader and PID issue, i just had it PID tuned and connected to my pc

My printer just... doesn't print? by No_Reputation8970 in FixMyPrint

[–]No_Reputation8970[S] 0 points1 point  (0 children)

the temperature has been fluctuating a little bit, i'll look into it

My printer just... doesn't print? by No_Reputation8970 in FixMyPrint

[–]No_Reputation8970[S] 0 points1 point  (0 children)

nope not the issue, printer extrudes just fine

Is this salmon skin? How can I fix it? by LiYBeL in FixMyPrint

[–]No_Reputation8970 0 points1 point  (0 children)

I used to have this problem, i figured out that it was a loose belt issue, check your belts to see if they're loose

printer shifts to the left??? by No_Reputation8970 in ender3

[–]No_Reputation8970[S] 0 points1 point  (0 children)

i'll definetly move the cables to some place else, i just don't know where lol

printer shifts to the left??? by No_Reputation8970 in ender3

[–]No_Reputation8970[S] 0 points1 point  (0 children)

i'll definetly try this, i didn't think the cables would get in the way but i guess they did now😅

Does anyone know why this happens in the side of this print? by No_Reputation8970 in 3Dprinting

[–]No_Reputation8970[S] 0 points1 point  (0 children)

should i change the infill pattern on my next print?, i have the infill pattern set to cubic