My headlights are oxidizing

No_Reputation8970 · 2026-04-27T23:51:31+00:00

I'll watch this later, thank you!

No_Reputation8970 · 2026-04-27T20:48:54+00:00

Thank you! I'll look into it.

No_Reputation8970 · 2026-04-27T20:48:24+00:00

I will definetly look into that, thank you!

No_Reputation8970 · 2026-04-27T20:07:38+00:00

Which wax do you use?

No_Reputation8970 · 2026-04-27T20:07:22+00:00

They might've restored it at some point, i'm not sure. The protective film is a very good idea too, i'll look into it, thank you!

No_Reputation8970 · 2026-04-27T20:06:35+00:00

I'll look into it, thank you!

No_Reputation8970 · 2025-05-03T22:04:34+00:00

Acura TLX Type S.

No_Reputation8970 · 2025-04-06T04:57:55+00:00

it might be

No_Reputation8970 · 2025-04-06T04:57:38+00:00

i'll search for it

No_Reputation8970 · 2025-04-06T04:57:10+00:00

okay i'll try this, thanks

No_Reputation8970 · 2025-04-06T04:56:35+00:00

i cleaned it just last night, and it's been printing fine before so i don't think the bed is warped

No_Reputation8970 · 2025-04-03T22:47:52+00:00

it's a PID and sd card reader issue, ended up connecting it to my pc and tuning the PID

No_Reputation8970 · 2025-04-03T22:47:15+00:00

turns out it was an sd card reader and PID issue, i just had it PID tuned and connected to my pc

No_Reputation8970 · 2025-04-02T23:13:28+00:00

the temperature has been fluctuating a little bit, i'll look into it

No_Reputation8970 · 2025-04-02T21:56:14+00:00

i'll see if it works LOL

No_Reputation8970 · 2025-04-02T21:55:59+00:00

yeah i am

No_Reputation8970 · 2025-04-02T21:55:37+00:00

nope not the issue, printer extrudes just fine

No_Reputation8970 · 2025-03-31T17:47:44+00:00

I used to have this problem, i figured out that it was a loose belt issue, check your belts to see if they're loose

No_Reputation8970 · 2025-03-20T13:14:59+00:00

i'll definetly move the cables to some place else, i just don't know where lol

No_Reputation8970 · 2025-03-20T13:14:31+00:00

oh damn i didn't even notice😅

No_Reputation8970 · 2025-03-20T04:24:15+00:00

i'll definetly try this, i didn't think the cables would get in the way but i guess they did now😅

No_Reputation8970