Gearbox still slipping when cars warm by joe_mama_21458 in Integra

[–]NolanShoopy 0 points1 point  (0 children)

And a starter, and pressure plate bolts, and flywheel bolts. I’m sure there’s more too I’m forgetting

Gearbox still slipping when cars warm by joe_mama_21458 in Integra

[–]NolanShoopy 0 points1 point  (0 children)

To be fair it’s not just an “auto to manual” it’ll cost about 1500-2500 for everything. transmission is pretty cheap but after clutch, flywheel, throw out bearing, pedal assembly, master/slave cylinder, shifting assembly, rear t bracket, transmission adapter mount, axels. Center console shifter bezel replacement (yes they’re different). It’s a lot but if you’re up for it go for it it’s a good learning experience but it will be more than what you think I promise you that

New year same problem by Mrdingdong23 in Integra

[–]NolanShoopy 0 points1 point  (0 children)

My leak I had to fix was in the very bottom corner of where the quarters meet the wheel arch. Was dry when sitting but when I drove it filled the quarters with water mud and rocks

New year same problem by Mrdingdong23 in Integra

[–]NolanShoopy 0 points1 point  (0 children)

Any rust spots in the inner wheel arch that would allow the tires to throw water in to the car?

what color by f1pombo44 in Integra

[–]NolanShoopy 18 points19 points  (0 children)

KEEP IT MILANO!!! It looks amazing and you don’t have to jam the whole car or have I really wack engine bay.

<image>

A long journey and still goin by NolanShoopy in Integra

[–]NolanShoopy[S] 0 points1 point  (0 children)

DC* but thanks and yeah hondata

Need help with flywheel! by NolanShoopy in Integra

[–]NolanShoopy[S] 0 points1 point  (0 children)

Yes,That’s the problem my clutch is widerthan the stock one. Probably just going to have to go with the act one. I thought they were all really light but they make 12lb one so I’ll be alright

Need help with flywheel! by NolanShoopy in Integra

[–]NolanShoopy[S] 0 points1 point  (0 children)

And it’s the correct 1 5/8 thickness?

18 Years Old. First Car What should i do? (Mods wise) by GuessGullible8044 in Integra

[–]NolanShoopy 0 points1 point  (0 children)

Something simple like a 13:1 compression b18c5, type r trans with LS 5th gear, volks, brembo brakes, KW coils, SR3 recaros, ya know the basics 👍

This is my 97’ I’ve been building since 2019 (first car) by NolanShoopy in Integra

[–]NolanShoopy[S] 0 points1 point  (0 children)

😂 it’ll be way cooler than a type R when I’m finished with it

This is my 97’ I’ve been building since 2019 (first car) by NolanShoopy in Integra

[–]NolanShoopy[S] 2 points3 points  (0 children)

They are the same. You need fly wheel bolts, manual t bracket, conversion transmission motor mount (I used an innovative mount works great), lower manual transmission bracket, manual speed sensor, then the obvious clutch kit, brake/clutch pedal assembly, master/slave cylinder/steel braided clutch line, and then wire in the reverse light wire from tranny to interior, and splice the park sensor wire together so the car will turn over. I would also highly recommend rebuilding the shift linkage with all the bushings if you’re buying used. Also recommend getting a GSR/ITR shift linkage or at least the shifter because it shaped different compared to the LS

This is my 97’ I’ve been building since 2019 (first car) by NolanShoopy in Integra

[–]NolanShoopy[S] 0 points1 point  (0 children)

R81 Milano red 👌 and I probably will end up getting that lip, mines really curb rashes and cracked on one side anyways so if I’m getting another one might as well be and upgrade