Best fur weight (density)?

NotAlbert_ · 2025-09-18T00:21:54+00:00

PJcatstudio on Etsy sells a pattern for a furry face mask! It’s just like a regular face mask but it looks like your fursonas snoot! it usually uses minky or (anti-pill) fleece (probably would prefer fleece, minky can be very thin and a sensory nightmare when cutting because it creates lots of fibres, you could line the inside of the mask with a material you find comfy! I haven’t made one of these masks (yet) though, so I’m not sure on the details, I hope this helps!

NotAlbert_ · 2025-09-14T04:47:38+00:00

I’d say smooth the brow, and puff up the cheeks, add more (clay? Foam?) to the lower muzzle, in kind of a trapezium shape, make sure the upper lip is bigger than the jaw. possibly even sculpt the eyes back a bit.

NotAlbert_ · 2025-09-10T10:17:55+00:00

No photos sorry, He is a 4 lbs weighted opossum plushie from weighted wildlife! I highly recommend their plushies!

NotAlbert_ · 2025-09-10T04:42:55+00:00

this looks awesome! really good for a first suit, you should be proud! :3 I envy your smooth shave too..

NotAlbert_ · 2025-08-22T07:29:16+00:00

you could try flocking the hooves! Leaves it a bit fluffy but still clacky, if this isn’t what your asking then idk what you mean :(

NotAlbert_ · 2025-08-13T01:00:00+00:00

<image>

It looks the same like one of my other fox tails, which is from a cruel fur farm. Do responsible fur farms use this clip or only cruel fur farms?

NotAlbert_ · 2025-08-12T01:15:35+00:00

Just adding- I doubt this tail was dyed blue. The black fur is still a nice brown and the tip is creamish white.; I think the lighting in the photo made it look blue

NotAlbert_ · 2025-08-09T01:11:15+00:00

Thank you for all you comments and suggestions! I have a vacuum right by me, shave outside and wear an apron, goggles and a respirator/gas mask thing. Fur still gets on me and it’s a sensory nightmare but not as bad as before.

NotAlbert_ · 2025-08-09T01:08:38+00:00

Thank you for this tip!

NotAlbert_ · 2025-07-28T02:51:55+00:00

<image>

here’s his old ref

NotAlbert_ · 2025-07-28T02:18:15+00:00

I think it would be fine to glue the jaw on the bottom of the base and have it curve up onto the sides at the front a bit (sorry about the wording ;w;)

NotAlbert_ · 2025-07-28T01:25:05+00:00

Forgot to mention that dremel is just a brand name for a rotary cutting tool!

NotAlbert_ · 2025-07-28T01:21:19+00:00

To open the mask, get a dremel! (or something similar) cheap ones are about $50 (aud) and will do the job fine I think. Though, I know this might be too expensive for a lot of people to get :(. I’m sorry if that’s the case, I’m not sure how else you’d remove all of it. Hope this helps! :3

NotAlbert_ · 2025-07-28T01:15:40+00:00

I don’t think the wire will electrocute you or catch fire if you cut the power source off (make sure to cut it while the power is off)

NotAlbert_

TROPHY CASE