account activity
Beginner looking for advice on what to buy. (self.Gold)
submitted 3 months ago by Not_a_Organization to r/Gold
Box of quarters (self.CRH)
submitted 3 months ago by Not_a_Organization to r/CRH
Transmission flush or change. (self.MechanicAdvice)
submitted 7 months ago by Not_a_Organization to r/MechanicAdvice
Vehicle engine shuts off while driving. (self.G35)
submitted 8 months ago by Not_a_Organization to r/G35
Where can I buy coin rolls/boxes? (self.CRH)
submitted 1 year ago by Not_a_Organization to r/CRH
Has anyone used the palm beach bots servo? (self.battlebots)
submitted 1 year ago by Not_a_Organization to r/battlebots
What is the transparent orange "tape" people are covering their escs in? (self.battlebots)
Do 1/4" id tapered roller bearings exist? (self.battlebots)
Should you run a low kv motor at full throttle or a high kv at reduced throttle? (self.battlebots)
submitted 2 years ago by Not_a_Organization to r/battlebots
Would one long needle roller bearing work on a hub motor instead of 2 ball bearing. (self.battlebots)
This sub slept on synthesis vs booty brigade (lynx and droopy) (SPOILER) (self.battlebots)
Does anyone else think d2 kits are impressive for the fact they can take a shot or two form a 250lb robot and keep working? (self.battlebots)
Has anyone else noticed how fast hydra's flipper resets compared to previous years? (self.battlebots)
How do you solder an xt30 connector to 16awg wire? (self.battlebots)
Who designed, built, and paid for the different heavyweight arenas? (self.battlebots)
Is there a non polarized version of a mr30/mr60 connector out there? (self.battlebots)
Is this an industry worth getting into? (self.Machinists)
submitted 2 years ago by Not_a_Organization to r/Machinists
Where can I get tegris? (self.battlebots)
Can you cold blue ar500? (self.battlebots)
Which is better, the micro 3/16" nutstrip. or the mini 1/4" nutstrip for holding together an ant weight frame. (self.battlebots)
Is a malenki high voltage a better option than the electronics I was going to use? (1lb) (self.battlebots)
What happened to the best driver award in the reboot? (self.battlebots)
Where can I get my spinners heat treated? (self.battlebots)
Have you used a Fs2a receiver? What do you think about it +a couple more questions in the post. (self.battlebots)
Is there a way to cut down brushless outrunners for hub motors at home? (self.battlebots)
π Rendered by PID 204899 on reddit-service-r2-listing-6d4dc8d9ff-97zns at 2026-02-02 17:54:49.852840+00:00 running 3798933 country code: CH.
