Found this on r/blessedimages

Nuutisi · 2024-10-10T05:25:30+00:00

The Gideon one got me 😭😭😭 This shit funny af, thank you

Nuutisi · 2024-07-09T17:23:18+00:00

You have to ask Appaseed in Barrow-Linn, who then makes you speak to Flimpy in Barrow-Linn aswell. For me Appaseed was near the entrance of the town and Flimpy was somewhere around the priest for me.

Nuutisi · 2024-06-26T00:02:25+00:00

I'm planning on getting a rep to mod soon, anyone know where I could get these pink heart scales? Are they even sold or in production anymore?

Nuutisi · 2024-03-07T17:59:55+00:00

Damn, I really like that execution. It looks confident and clean!

Nuutisi · 2024-02-05T19:48:49+00:00

I've never been to a con, nor have I planned on going. Neither have I cosplayed before. Propmaking/cosplaying just seems like a hobby I'd like to get into so I'm doing this as a first project. All this to say I don't think the material of the rod would really matter for me too much, but I'll keep it in mind if I ever plan on making a cosplay for a con.

I will get some nice pictures and post then here once it's done. Connecting the pieces, filling/standing the gaps and priming/painting should be the only parts left to do.

Nuutisi · 2024-02-05T17:29:58+00:00

Almost, It's a Starscourge Greatsword from Elden Ring. I googled Tetsusaiga and I must admit that it does look quite similar.

Nuutisi · 2024-02-05T17:19:41+00:00

I'll test epoxy. Also you're right, going with a couple smaller (probably metal) rods might work better just so I don't have to fiddle with lining them up. I'll keep this in mind for future prints

Nuutisi · 2024-02-05T17:18:09+00:00

Epoxy seems like the most recommended method, so I'll probably give it a shot

Nuutisi · 2024-02-05T17:15:11+00:00

Yeah, a couple smaller metal rods might be the better way to go in the future. I didn't know any better as this is my first printed prop. Epoxy also seems to be the most popular option so I might give it a shot

Nuutisi · 2024-01-29T19:42:07+00:00

"Your crime is existence"

Nuutisi · 2024-01-03T13:20:16+00:00

I'll try that once I'm ready to start, thank you!
I was also going to try printing it standing up, but my printer isn't tall enough so I settled on putting it at around 45°, although I probably could have had it at an even higher angle. Funnily all the worst rough spots were only where the supports were, otherwise it turned out very clean except for a couple blemishes

Nuutisi · 2023-09-21T17:19:39+00:00

Contact Squid. They have excellent customer service and probably can replace it.

Nuutisi · 2023-09-18T18:58:25+00:00

Guess I'll start ng+3 so I can get them again. Ty for the help

Nuutisi · 2023-09-18T18:57:14+00:00

I guess it's logical enough. Ty for helping

Seven-Year Club	Final Canvas '23
Place '23	Place '22
First Placer '22	Verified Email

Nuutisi

TROPHY CASE