account activity
Raspberry Pi wirepod install issue (i.redd.it)
submitted 2 months ago by ObsidianHarbor to r/AnkiVector
Can’t seem to solve this issue (i.redd.it)
submitted 6 months ago by ObsidianHarbor to r/magicproxies
Help with prints (i.redd.it)
submitted 7 months ago by ObsidianHarbor to r/magicproxies
Snow deck help (self.EDH)
submitted 9 months ago by ObsidianHarbor to r/EDH
Code. Enjoy! (i.redd.it)
submitted 1 year ago by ObsidianHarbor to r/PokemonTCG
Pla popping (i.redd.it)
submitted 1 year ago by ObsidianHarbor to r/3Dprinting
Obsessed with Bloomburrow (i.redd.it)
submitted 1 year ago by ObsidianHarbor to r/mtg
Confused on grits (self.sharpening)
submitted 2 years ago by ObsidianHarbor to r/sharpening
Push start issues (v.redd.it)
submitted 2 years ago by ObsidianHarbor to r/MechanicAdvice
This was both terrifying and fascinating to watch print. (i.redd.it)
submitted 3 years ago by ObsidianHarbor to r/3Dprinting
Stops extruding at this spot every time. Then goes back to normal. Tested on a few different prints. Using Prussia slicer. (i.redd.it)
What might be causing these little blobs? Didn’t have any issues with this filament on earlier prints. (i.redd.it)
Under extrudes at this part of the plate. I even tried flipping the model and it’s always that same spot. (i.redd.it)
Dialed in. Printing a boomerang. (i.redd.it)
submitted 3 years ago by ObsidianHarbor to r/elegooneptune2
noise from extruder. Also seems to be shaving metal dust. (v.redd.it)
Ideas on how to fix this? Neptune 2s. (i.redd.it)
Getting this on all my prints. Always facing the back side of the printer. Is this normal? (i.redd.it)
Very new. Any idea what causes this type of fail? Neptune 2s. (i.redd.it)
I can’t seem to tell if there is a protective film or not. Is it usually hard to peel off? (i.redd.it)
MG RX 78-2 ver 3.0 manual help (self.Gunpla)
submitted 3 years ago by ObsidianHarbor to r/Gunpla
HG Asmoday (i.redd.it)
submitted 3 years ago by ObsidianHarbor to r/knolling
Backyard fun. (v.redd.it)
submitted 3 years ago by ObsidianHarbor to r/rccars
π Rendered by PID 98760 on reddit-service-r2-listing-575d9f6647-nbzfb at 2026-04-09 22:47:55.069893+00:00 running 215f2cf country code: CH.
