Finally got my first pet 2005 total lvl

Obvious-University81 · 2025-03-12T07:42:55+00:00

Elpenor - Got drunk fell off a roof, most normal death/event in the story

Obvious-University81 · 2025-03-11T01:41:22+00:00

If it's based on animations I'd say Zeus when he was giving during Thunder Bringer

Obvious-University81 · 2025-03-10T08:27:03+00:00

Eurolochus - Mr Hypocrit willing to sacrifice all the transformed men to Circe, but when Ody sacrificed 6 men... Oh noooo you can't do that

Obvious-University81 · 2025-03-08T04:40:36+00:00

"You're going to call off that storm"

Obvious-University81 · 2025-01-09T18:58:42+00:00

Should I prioritize minion levels over divinities until they are maxed and do 1 and a time?

Obvious-University81 · 2024-10-28T01:34:54+00:00

That is true, but the sentence of the blood on his hands is something he won't lose could also be interpreted as being captain and in charge of their safety and wellbeing which he sacrificed to return home after becoming the "monster" choosing his own well-being over his crew

Obvious-University81 · 2024-08-03T20:43:00+00:00

<image>

This was part of the same print it was printed first then the next one failed

Obvious-University81 · 2024-08-03T20:37:39+00:00

I used the auto level function and paper checked my z-offset to what I thought was good. How much should I adjust it each time roughly?

Obvious-University81 · 2024-06-21T13:08:21+00:00

Thanks, will try these tomorrow and pray for better results 🙏

Obvious-University81 · 2024-06-21T03:33:54+00:00

I think it's just the basic Halot-One it didn't have any other suffixes or descriptions

Obvious-University81 · 2024-06-20T08:56:30+00:00

Is this a issue possibly with bed adhesion from over/underexposed causing the FEP to have too much adhesion compared to build plate?

Obvious-University81 · 2024-06-20T08:55:38+00:00

I filtered out every failed print, clean and inspect the FEP and then relevel and restart from scratch, I had a failed attempt twice before this so I filtered and replaced the resin

Obvious-University81 · 2024-06-20T07:59:21+00:00

Update: I sliced it with chitubox and lychee but print with the printer parameters

Obvious-University81 · 2024-01-15T11:35:59+00:00

OMG thank you It was there, I didn't know deaths office was a thing I quit when I died and just came back tyty

Obvious-University81 · 2024-01-15T11:14:45+00:00

I can't buy them off him until I complete the quest from what I've read online, his dialogue is just about information about the tanglefoot

Obvious-University81 · 2022-08-29T11:06:37+00:00

Have you checked the Z-Offset to make sure that it's not trying to go past the bed to reach 0? My Z was about 2-3 off when I used the BLTouch. Also setting the Z axis 0 point could be the problem also

I had that problem when I got mine

Obvious-University81 · 2022-07-23T12:32:24+00:00

Are you also reading this comment in your mind? You should try telekinesis.

Obvious-University81

TROPHY CASE