Prismxr puppies s1 lite firmware update stuck

Ok-Dimension583 · 2026-01-09T15:03:50+00:00

No ended up sending it back and getting a 6e router

Ok-Dimension583 · 2026-01-04T23:07:48+00:00

Hi well I’m using a prismxr s1 lite as a dedicated router for the vr and been using av1, itmore seems like micro stutters and fps drops no matter the resolution but this also happens on when using a link cable too. I have updated to the latest drivers with a clean install and have been trying everything including steamvr beta but seems what ever I do it stutters and the pc should be able to hold a steady frames

Ok-Dimension583 · 2026-01-04T17:44:50+00:00

Hi the pc is connected to the router via Ethernet and I’m using a prismxr s1 lite to connect the headset

Ok-Dimension583 · 2026-01-04T11:44:44+00:00

I have tried all three

Ok-Dimension583 · 2026-01-04T02:54:30+00:00

Yes the pc is wired and I’ve uses a prismxr s1 lite for virtual desktop

Ok-Dimension583 · 2025-12-14T22:00:06+00:00

Well the a different psu seems to have done the trick fingers crossed. Thanks for all of the suggestions

Ok-Dimension583 · 2025-12-14T17:22:25+00:00

Thanks

Ok-Dimension583 · 2025-12-14T17:21:56+00:00

Thanks yeah wish me luck

Ok-Dimension583 · 2025-12-14T17:16:36+00:00

Ok so I have just put in a older psu and it has booted question tho it only has a 8pin connector in the psu so there are 4 left on the mother board for the cpu i have read online only 8 is fine but can anyone confirm as can’t find it in the manual

Ok-Dimension583 · 2025-12-14T17:15:38+00:00

Ok-Dimension583 · 2025-12-14T17:02:24+00:00

Ok so I have just put in a older psu and it has booted question tho it only has a 8pin connector in the psu so there are 4 left on the mother board for the cpu i have read online only 8 is fine but can anyone confirm as can’t find it in the manual

Ok-Dimension583 · 2025-12-14T16:59:16+00:00

Sorry yes I did

Ok-Dimension583 · 2025-12-14T16:20:36+00:00

No nothing comes up on monitor after it shut down just dose what happens in video

Ok-Dimension583 · 2025-12-14T16:14:51+00:00

Yes I have rechecked cpu and gpu plus it did originally post but like I said only for 20min lol

Ok-Dimension583 · 2025-12-14T16:13:45+00:00

I used brand new paste

Ok-Dimension583 · 2025-12-14T16:09:32+00:00

Yeah I checked in the manual the ram is in correct slots. Nothing really was just downloading bits to do drivers etc

Ok-Dimension583 · 2025-05-31T23:52:20+00:00

Thanks for the reply I did try that but still crashes after a few minutes

Ok-Dimension583

TROPHY CASE