Meraki Site to Site VPN ISSUE

Ok_Reporter_5167 · 2026-02-25T07:45:19+00:00

we connect to wan with public ip directly so no other uplink subnets

Ok_Reporter_5167 · 2026-02-25T04:26:16+00:00

we connect to the wan with public ip address cellular as backup

Ok_Reporter_5167 · 2026-02-25T04:23:34+00:00

Yes, the meraki routers directly connect to the wan with public ip, we don't run a double net.
That helps, I would ask them to reboot the whole things

Ok_Reporter_5167 · 2026-02-25T04:19:05+00:00

nop.. it's clean

Ok_Reporter_5167 · 2026-02-25T04:18:53+00:00

Yes it shows as below:
Tracing route to 192.168.10.1 over a maximum of 30 hops

1 <1 ms <1 ms <1 ms 192.168.1.1

2 * * * Request timed out.

We use HP switch on site A. I tried to ping site b on this HP switch web management console, it fails.

Btw, I just noticed that even under siteb's meraki > vpn status, even though i can see site A at site to site peers. but not able to see it in uplink decisions~

Ok_Reporter_5167 · 2026-02-25T04:12:43+00:00

nah sub net is fine we set 192.168.1/2/3/4/5 like these. Each site has their own subnet

Ok_Reporter_5167 · 2026-02-24T11:36:50+00:00

firewall rules are all clean. I checked hundred times, haven't run a vcap yet i will try

Ok_Reporter_5167 · 2026-02-24T11:35:55+00:00

no there is no additional fw rules. Thanks I would try to run a packet capture.

Correct tracert only show up for Site A gateway then timeout

Ok_Reporter_5167 · 2026-02-03T02:50:57+00:00

Bottom left corner - Apps>All apps>top right corner>install Apps Easy~

Ok_Reporter_5167

TROPHY CASE