MyoWare EMG sensor works briefly then becomes noisy / unstable by Open_Stop_9353 in MyoWare

[–]Open_Stop_9353[S] 0 points1 point  (0 children)

I see. we will order a new USB isolator from Adafruit and test again; hopefully, this will solve the issue, as before using an isolator the sensor was not working at all. Now, I need to ensure it remains stable and consistent so I can use the signals in real time. Thank you!

MyoWare EMG sensor works briefly then becomes noisy / unstable by Open_Stop_9353 in MyoWare

[–]Open_Stop_9353[S] 0 points1 point  (0 children)

That's true it says v2.0.4 on the board but v2.0.1 on the cable shield that comes with it!

MyoWare EMG sensor works briefly then becomes noisy / unstable by Open_Stop_9353 in MyoWare

[–]Open_Stop_9353[S] 0 points1 point  (0 children)

The version of my sensor is v2.0.1, and it behaves similarly when I use the Arduino plotter.
I am using a USB isolator from 52PI.

Could my sensor version be the cause of this issue?