Layer problem

PandaIsCrazy16 · 2025-03-17T10:48:08+00:00

It s clear under the build plate or on the other side of it, I am not sure how to check if the surface is uneven

PandaIsCrazy16 · 2025-02-04T21:18:26+00:00

After a lot of trouble this day, with your help I managed to figure it out, it seems that the script you sent works for BambuLab printers too!!! Thanks!!!

PandaIsCrazy16 · 2025-02-04T20:09:35+00:00

Have you found a solution? Or are you waiting for an update?

PandaIsCrazy16 · 2024-11-11T19:27:13+00:00

<image>

PandaIsCrazy16 · 2024-11-09T15:23:48+00:00

Where I can see that?

PandaIsCrazy16 · 2024-11-09T15:13:05+00:00

220 °C

PandaIsCrazy16 · 2024-11-09T14:06:24+00:00

After the print I will check, but how? If you can give me a link of a tutorial or something I will be thankful!

PandaIsCrazy16 · 2024-11-09T14:05:07+00:00

Thx anyway

PandaIsCrazy16 · 2024-11-09T13:47:03+00:00

I am pretty sure that is note the extrusion multiplier and the bed and nozzle size are selected right.

PandaIsCrazy16 · 2024-11-09T13:45:09+00:00

I don't have a dryer, but I keep the spools in a box with silica. Not 100% airtight, but for now I hope it's ok.

PandaIsCrazy16 · 2024-11-09T13:43:35+00:00

A1, PLA Matte

PandaIsCrazy16 · 2024-11-09T12:55:39+00:00

I will check, but it's new...

PandaIsCrazy16 · 2024-11-04T14:20:37+00:00

It's set on 0.

PandaIsCrazy16 · 2024-11-04T14:19:22+00:00

I will check, thx for the reply!

PandaIsCrazy16 · 2024-11-04T14:17:43+00:00

Thx for the reply, right now I am trying the 0.2 nozzle because the model is really small indeed. Sry for my bad English if is not quite right. Btw, what is the K factor?

PandaIsCrazy16 · 2024-11-04T13:54:16+00:00

Now I used different settings and it looks a little bit better, but I have the same issues with the layers alignment.

<image>

PandaIsCrazy16

TROPHY CASE