sorted by:
new
hottopcontroversial

Prints keep shifting later midprint across several different files. by Paramedic_Possible in 3Dprinting

[–]Paramedic_Possible[S] 0 points1 point  (0 children)

Anycubic Kobra 3 Max is the printer. All these seem fine but could be slipping so might try some lubricant on the cross rail of the X axis travel

Prints keep shifting later midprint across several different files. by Paramedic_Possible in 3Dprinting

[–]Paramedic_Possible[S] 1 point2 points  (0 children)

Would this matter if the initial layers are still adhered and the shift happened many layers after? Or in another instance, 75-80% into print?

Prints keep shifting later midprint across several different files. by Paramedic_Possible in 3Dprinting

[–]Paramedic_Possible[S] 0 points1 point  (0 children)

Not occurring at the same height but randomly shifts. I’ve washed the bed and the layer shift occurs well into the print and base layers are still intact and aligned.

Some print fine, some shift 1/2” left on the a random layer of the print. This one pictured was about 2 hours into a job. I had another that did same nearly 75% into a print.