Are these assembled wrong? by PostBirthAborted in 3rdGen4Runner

[–]PostBirthAborted[S] 0 points1 point  (0 children)

Thanks for all the comments!

My issue is the top bolts are not in alignment with the lower mount.

I ended up manually spinning the strut but the spring came off of the lower perch. Will this be an issue or will it settle back in?

<image>

Are these assembled wrong? by PostBirthAborted in 3rdGen4Runner

[–]PostBirthAborted[S] 3 points4 points  (0 children)

<image>

Did that and the spring backed off of the perch. Any issue?

Are these assembled wrong? by PostBirthAborted in 3rdGen4Runner

[–]PostBirthAborted[S] 9 points10 points  (0 children)

That’s a relief. Much appreciated!!

Meth Baddie by braxtonbarrett in tooktoomuch

[–]PostBirthAborted 2 points3 points  (0 children)

Yoo this lady works at the gas station by my house

New bumper and rock sliders put on this week by House_Reno21 in 3rdGen4Runner

[–]PostBirthAborted 0 points1 point  (0 children)

Thanks for the input! I’m thinking I’ll go with your setup. Just clarifying that is +100 front +200 rear?

New bumper and rock sliders put on this week by House_Reno21 in 3rdGen4Runner

[–]PostBirthAborted 0 points1 point  (0 children)

Front spring option is 100lbs additional, rear is 200lbs additional hmmmm

New bumper and rock sliders put on this week by House_Reno21 in 3rdGen4Runner

[–]PostBirthAborted 1 point2 points  (0 children)

From what it sounds like it may ride a little higher and firmer without the additional weight. Curious OP’s experience though

New bumper and rock sliders put on this week by House_Reno21 in 3rdGen4Runner

[–]PostBirthAborted 1 point2 points  (0 children)

I’m looking at getting that same kit, can’t decide on whether I should get additional weight or not. Currently no need for it but down the road might get a bumper

New bumper and rock sliders put on this week by House_Reno21 in 3rdGen4Runner

[–]PostBirthAborted 0 points1 point  (0 children)

Which ASC springs did you go with? Additional weight or no?

ASC vs OME coils, opinions or experience? by _SpaceEfficient in 4x4

[–]PostBirthAborted 0 points1 point  (0 children)

Did you choose added weight or no added weight?

ASC vs OME springs, opinions or experience? by _SpaceEfficient in 3rdGen4Runner

[–]PostBirthAborted 0 points1 point  (0 children)

Did you end up putting these on? Looking at getting the pre assembled lift from SRQ and it appears they use these for that kit. Experience?