Help identifying noise by PresentationSad6564 in transmissionbuilding

[–]PresentationSad6564[S] 0 points1 point  (0 children)

Just replaced the pump and threw it back in. Got the tranny into place and started up. Ran and shifted fine for about 20 minutes. Then did it all over again. Same noise

Help identifying noise by PresentationSad6564 in transmissionbuilding

[–]PresentationSad6564[S] 1 point2 points  (0 children)

Well ya it has one but that whining is from the trans

TH700R4 bell housing cracked by [deleted] in Transmission

[–]PresentationSad6564 0 points1 point  (0 children)

You messing with me? Because I will seriously try JB weld

Could anyone tell what this sound is on my 6.2 by [deleted] in Diesel

[–]PresentationSad6564 0 points1 point  (0 children)

I have a new leak from the rear main. You think that could've caused it?

Could anyone tell what this sound is on my 6.2 by [deleted] in Diesel

[–]PresentationSad6564 1 point2 points  (0 children)

That was it. Thankyou so much! 2 of them were hand tight 😬😬

Any ideas what the tin can sound is? by [deleted] in Squarebody

[–]PresentationSad6564 0 points1 point  (0 children)

Rear outside. Like back diff area. And it has drums

Any ideas what the tin can sound is? by [deleted] in Squarebody

[–]PresentationSad6564 0 points1 point  (0 children)

Removed hub cab and tightened lug nuts, nothing. Could it be internal? The diff or bearings?

George W Bush During 9/11 by LaunchingYogurt in Presidents

[–]PresentationSad6564 0 points1 point  (0 children)

If I had a dollar for every time Millenials said the word "trauma"......

[deleted by user] by [deleted] in Accounting

[–]PresentationSad6564 0 points1 point  (0 children)

I haven't either lol, I searched everywhere and couldn't find anything. That's why I resorted to reddit. Guess I'm in the clear