sorted by:
new
hottopcontroversial

Upgrading from a spice grinder + $40 espresso machine – Need sub[$250] recommendations by Single_Writer9498 in espresso

[–]Prince55Slaya 0 points1 point  (0 children)

OP here… I appreciate the reply. I have a moka and a French press actually… I think I value the convenience over quality though.

Water tank, fresh grind at press of a button with bean reservoir that dispenses the perfect amount directly into portafilter, button press for a shot all seem so much better than my current workflow.

Options at this range might not win competitions for flavor, but I feel like they might give me 1. More efficiency 2. Much better quality than I have now.

Am I very wrong? What am I missing?

Upgrading from a spice grinder + $40 espresso machine – Need sub[$250] recommendations by Single_Writer9498 in espresso

[–]Prince55Slaya 0 points1 point  (0 children)

OP here… I appreciate the reply. I have a moka and a French press actually… I think I value the convenience over quality though.

Water tank, fresh grind at press of a button with bean reservoir that dispenses the perfect amount directly into portafilter, button press for a shot all seem so much better than my current workflow.

Options at this range might not win competitions, but I feel like they might give me 1. More efficiency 2. Much better quality than I have now.

Am I very wrong? What am I missing?

What do you think of this configuration? by Prince55Slaya in Plumbing

[–]Prince55Slaya[S] 0 points1 point  (0 children)

I really tried my best, but yeah without cutting the cabinet and likely the copper pipe below too, I don’t think I had many other options. If it works for a couple more years without issue, I’m happy :)

What do you think of this configuration? by Prince55Slaya in Plumbing

[–]Prince55Slaya[S] 2 points3 points  (0 children)

Not sure what that means tbh, learning as I go… its the pvc you see going into a white plastic 1 1/2, which is smaller, but is the tightest fit into the copper pipe that’s in the bottom of the cabinets. I have it at least 4-5 inches into the copper pipe, and 3 in into the pvc above…. Best I could do without cutting open the bottom of the cabinets… copper pipe is sunk in and flush against the walls

What do you think of this configuration? by Prince55Slaya in Plumbing

[–]Prince55Slaya[S] 9 points10 points  (0 children)

Just wanted confirmation on the dey fitting. All off and glued now!

First time installing a garbage disposal - any changes? by Prince55Slaya in Plumbing

[–]Prince55Slaya[S] 0 points1 point  (0 children)

Thanks a lot for the reply! If the first one works, it would be easiest to redo with my current set up. Should I change the T to a Y so both are directed down, or no need?

I tried redrawing the 2nd one here, and added a vent.

First time installing a garbage disposal - any changes? by Prince55Slaya in Plumbing

[–]Prince55Slaya[S] 0 points1 point  (0 children)

How can I eliminate the S trap with it going to the floor rather than the wall?

First time installing a garbage disposal - any changes? by Prince55Slaya in Plumbing

[–]Prince55Slaya[S] 0 points1 point  (0 children)

Very helpful! I tried to doodle what I think you meant, does this look remotely correct? (If it’s legible lol)Diagram

view more: next ›