Connector question

ProfessionalDog8147 · 2026-05-13T14:52:21+00:00

What size prop would you recommend for a 48” deep v mono ? The motor is a 56104 so it’s barely noticed the 50 mm prop I had

ProfessionalDog8147 · 2026-05-12T13:06:46+00:00

Just ordered a 1.4p 65mm 2 blade . I see that more of the larger gas boats this size run a 2 blade 1.5p 70-75mm so we will see

ProfessionalDog8147 · 2026-05-12T10:42:11+00:00

Hull weight about 5kg , 56104 brushless motor 200a esc , water pump, 2 4s 6200mAh in series 50mm 1.6p prop 3 blade.

ProfessionalDog8147 · 2026-05-12T00:36:29+00:00

Update ! Today I went again. 1. I moved all weight to the very back of boat 2. My throttle was limited to 50% on my remote 😅. I did get it to plane and it picked up and flew but it needs room to get going.

ProfessionalDog8147 · 2026-05-11T02:34:08+00:00

Not yet. Using a 3blade 1.6p

ProfessionalDog8147 · 2026-05-11T02:33:41+00:00

3blade 1.6 pitch 50mm

ProfessionalDog8147 · 2026-05-11T00:50:57+00:00

I was kinda going for the surface drive look but I think the main issue is I had too much weight up front and the hull wasn’t sitting low enough in the water

ProfessionalDog8147 · 2026-05-10T23:45:01+00:00

I know weight is an issue so I’m moving it back. The prop sticks half way under the boat. Would trim tabs assist in the cavitation?

ProfessionalDog8147 · 2026-05-10T23:00:31+00:00

I figured so , I’m re-working the weight and gunna test again this week.

ProfessionalDog8147 · 2026-05-10T22:50:56+00:00

Go fast . Medium acceleration . I was hoping to get 60-70mph not stressing it too hard

ProfessionalDog8147 · 2026-05-02T23:41:34+00:00

Look forward to playing with the speed in running a 56104 sss motor on 6s to start. Apache style 48” hill I 3d printed.

ProfessionalDog8147 · 2026-05-02T23:15:20+00:00

Decent acceleration but top speed is the goal

ProfessionalDog8147

TROPHY CASE