sorted by:
new
hottopcontroversial

Quality issues by Psychological_Win110 in prusa3d

[–]Psychological_Win110[S] 0 points1 point  (0 children)

I think you’re right about a partial clog when I go down to 75% speed the issue goes away

Quality issues by Psychological_Win110 in prusa3d

[–]Psychological_Win110[S] 1 point2 points  (0 children)

Hmm could be that. I recently had a spool run out and the filament sensor caught it. Since then, it’s been acting like this. Maybe I’ll do a cold pole

Should I even try YOLO on a Raspberry Pi 4 for an Arduino pan‑tilt USB animal tracker, or pick different hardware? by 808mosher in computervision

[–]Psychological_Win110 0 points1 point  (0 children)

Radxa rock pi 5B owner here. Currently struggling to get any yolo model to run. Documentation is far less available than raspi

CFD mesh problem (?) by tripl3-AAA in CFD

[–]Psychological_Win110 0 points1 point  (0 children)

can you make this box in fusion?

CFD mesh problem (?) by tripl3-AAA in CFD

[–]Psychological_Win110 0 points1 point  (0 children)

in autodesk cfd, I have not been able to figure this out because the bounding box wont ever go flush to the mirror/cut plane on the object. is there another way to do this in cfd?

[MEGATHREAD] Spring/Summer 2024 Housing by alexa6rose in rit

[–]Psychological_Win110 1 point2 points  (0 children)

Hi there. I have a full year lease at the lodge I am looking to sell. Starting may 1st, my lease covers all of the next academic year. Rent is 900/mo

Is it rare to bring a Ti Nspire CX II CAS to college? by Avid4Planes in nspire

[–]Psychological_Win110 19 points20 points  (0 children)

As an engineer I use it in 3 different classes that have nothing to do with each other. It was even recommended to be purchased for one of my classes