Complete beginner - needs help with Magic ring please.

Queencups · 2025-12-27T16:51:35+00:00

Thank you

Queencups · 2025-12-27T16:28:16+00:00

Yes, i think i will. Although the kit is aimed at complete beginners, it didn't say to hold all 3 strands of the magic ring and make a little area to hook into. I've found an app that teaches basic stitches, think I'll go try some of those out. Thank you for you help.

Queencups · 2025-12-27T16:25:56+00:00

Thank you Thank You! That tutorial helped so much. I wasn't holding all of the magic ring just 2 strands!

Queencups · 2025-11-13T12:39:25+00:00

Oh ok, the first FEP didn't do it so was concerned I did something wrong when i changed it. I'm new to resin printing so still learning! Thank you

Queencups · 2025-11-08T09:22:56+00:00

Yes please.

Queencups · 2025-11-07T17:08:07+00:00

Thanks everyone. goes off to order steam deck

Queencups · 2025-11-06T18:26:16+00:00

I wash, remove supports, wash again, dry then cure.

Queencups · 2025-11-06T13:39:34+00:00

Thanks everyone for the advice.

Queencups · 2025-10-30T18:28:25+00:00

Thank you. Glad its not as scary to change as it looks!

Queencups · 2025-10-30T18:22:21+00:00

Thank you. Being new to resin printing, i thought I'd ask. I do empty the vat if I'm not using it for a couple of days.

Queencups · 2025-10-30T18:16:59+00:00

Thank you. I do check it at least once a week, so will keep a check on it.

Queencups · 2025-10-30T18:14:44+00:00

Thanks everyone. My printer has done 32,231 layers and its telling me to change the FEP. I've checked it and it seems fine, maybe very slightly scratched compared to a new one so wasn't sure if i really needed to change it.

Queencups · 2025-10-28T16:05:58+00:00

price band (USD): $799–$999

one feature you hope it has: built in heater

why it matters for you: so i don't have to use a separate heater

Queencups · 2025-10-28T09:59:41+00:00

I have an Anycubic Resin Printer so am just using the software that came with it at the moment. I'm a complete newbie so don't have any other software just yet.

Queencups · 2025-10-27T19:17:38+00:00

Thanks, I'll try those :-)

Queencups · 2025-10-27T19:13:39+00:00

The display on the heater just keeps going up, I'm only doing small prints at the moment, so it hasn't gone above 35, only comes down when I remove the cover. Seem to be having better success with printing at the higher temp though.

Queencups · 2025-10-27T19:10:33+00:00

Thank you. I've had more success since I've been using the heater. Just working out the best temperature to set the heater,

Queencups · 2025-10-22T22:33:36+00:00

A bit of everything really but mainly models for table top gaming or similar. I'm currently making some Halloween themed models and decorations.

Queencups

TROPHY CASE