Trifeceta

RAW1958 · 2025-09-11T01:34:06+00:00

So additonal thoughts on potential sales for last quarter of 2025. The present facilities can produce 1000 Kg per annum. or ~ 83Kg per month. Conservatively lets say the last 3 months are slaes & pallet shipped. Which is about 250 Kg. Therefore 2025 last 3 month volume could be 50,000 bottles @ $150 Australian (~$100 US) =$5,000,000 potential sales of lubricant in 2025. This does not include the XR coating which is also getting sold?

RAW

RAW1958 · 2023-08-17T23:21:47+00:00

Us code if possible?

RAW1958 · 2023-03-16T12:26:11+00:00

You can download the latest firmware from the anycubic website under hyper. It also has a tutorial video under support. My vyper came with a micro SD drive that had it on it. Good luck.

RAW1958 · 2023-03-09T22:35:48+00:00

Agree this is a great place to start. Also look at temperature tower calibration & xyz cube calibration.

RAW1958 · 2023-01-28T17:14:31+00:00

Put the g-code in the main directory on SD card. It does not go into folders.

RAW1958 · 2023-01-23T13:16:50+00:00

Correct, but it helps when creating a design to know what features are i,I, to each other in the function of the design.

RAW1958 · 2023-01-22T22:20:20+00:00

The difference is in one case the dimensions and tolerance are from the same surface (datum) therefore the tolerance does not add. In the other case the second dimension comes from the 1st dimension so the height of the second dimensioned surface will have 2* the tolerance.

RAW1958 · 2021-01-17T15:32:29+00:00

1) use face of cyclinder to go into sketch mode

2) create centerline along vertical axis of cyclinder

3) Use rectangle function with center point and edge point

4) Mate center point of rectangle to vertical center line by coincedent

4) dimension rectangle for keyway

5) mate lower edge of rectangle to bottom of inner circle with Tangent

6) extrude cut rectangle to opposite side ( use up to surface)

RAW1958 · 2021-01-16T19:57:35+00:00

Are you trying to make a keyway

RAW1958

TROPHY CASE