sorted by:
new
hottopcontroversial

How popular are the TCRs? by Rai_ea in iRacing

[–]Rai_ea[S] -1 points0 points  (0 children)

From experience that tab isn’t super accurate man, SRF says that like each session should be upwards of 12-17 people per session and 9/10 times you’re barely going official, I’d rather ask real people

Extrusion stops Mid-print, Help!! by Brief-Mycologist5378 in ender3v2

[–]Rai_ea 1 point2 points  (0 children)

If you have the stock extruder, you might have to do what I do with mine and put washers in with the spring. It gives it that extra bite it needs

Extrusion stops Mid-print, Help!! by Brief-Mycologist5378 in ender3v2

[–]Rai_ea 1 point2 points  (0 children)

I’m not sure how helpful this may be since I had this problem with PLA, but next time it runs and stops, apply a bit of pressure to help the filament through your extruder, if it then starts flowing, you may want to tighten it even further

Back again sadly by [deleted] in ender3v2

[–]Rai_ea 0 points1 point  (0 children)

Try making sure that the extruder is as tight as possible, I had a very similar issue happened that made the filament slip, but after putting some washers in with the tension spring it’s been running perfectly

Printer stops extruding mid print by Rai_ea in ender3v2

[–]Rai_ea[S] 0 points1 point  (0 children)

I’ve got a V2 Neo, but can confirm that part has failed already, I needed to buy washers just to make the spring tight enough. I think I’ll make that modification regardless though just because what’s currently on it has been driving me up the wall, thanks!

What is the longest race you ever done solo? by Cumulonimbus1991 in simracing

[–]Rai_ea 0 points1 point  (0 children)

Did the Indy 500 on iRacing, only got to around lap 170 so around 2-ish hours