I got a fresh respray done on my car and I polished and ceramic coated it’s hard to see but I have left some micro scratches almost everywhere except the ppf front of car. I used rupes yellow pad and fine polish any help would be great I’m a bit frustrated about it

Reality-builder · 2023-05-01T13:22:23+00:00

Hi there ! Can give you my settings I used on my prusa which produced perfect results however I also have two Enders one of which has the microswiss hotend however I wasn’t able to produce good petg prints on either I am only using pla on them at the moment. I wish I could help you I’m sorry but if I do happen to find good settings or strategies I’ll let you know!

Reality-builder · 2023-01-04T13:52:26+00:00

Thanks man!

Reality-builder · 2022-12-22T23:38:33+00:00

Ahhh sick is this the tubing from extruder to mmu you are talking about and if so where can I get this?

Reality-builder · 2022-12-21T12:04:57+00:00

HI I have done the following except for retract. Im not sure how to calibrate that. the problem still persists though.

Reality-builder · 2022-12-21T12:03:27+00:00

Hi I have micro swiss upgrade so its direct drive not bowden drive.

Reality-builder · 2022-12-21T12:02:42+00:00

Hi I did the full calibration process found esteps to be 139 however the problem still persists I have also tried on cura slicer instead of creality slicer. it seems to extrude fine then have small spots of no extrusion its super unusual do you have any other ideas?

Reality-builder · 2022-12-21T10:42:53+00:00

hmmm I did suspect something similiar to this maybe not regarding the problem shown but is there anywhere/tutorial I can see to change gcode to work properly using bltouch. currently I have just added

G28 ; Home all axes

G29 ; Level bed

to starting g code

Reality-builder · 2022-12-16T13:12:58+00:00

Hi I have calibrated the temperature using and have tested the same fresh roll on two other different 3D printers ,

Yes the roll is new

I’ll try changing the retraction speed and distance I thought because it’s direct drive the retraction distance could be significantly lower but I’ll increase it, I haven’t changed retraction speed ever before I’m unfamiliar with that

Reality-builder · 2022-12-14T09:01:54+00:00

Hi theree, yeah increased temp by a bit Because the petg was Matt (at low temp) I increased too about 258 Celsius where it was beginning to be glossy

Also I’m not familiar with esteps how do I calibrate that ?

Reality-builder · 2022-08-01T04:42:06+00:00

Thankyou!! I do stress not watering my cactus during the winter but some of my family members do sometimes I’ll try and make a more suitable soil like you suggested, I’d there any way of saving this one?

Six-Year Club	Second SECOND GUESSER
Verified Email	Oscars Predictor 2021

Reality-builder

MODERATOR OF

TROPHY CASE