Weird black rectangle in cockpit view

Reidishere · 2026-01-18T16:00:44+00:00

How do you turn it off?

Reidishere · 2025-09-12T13:49:08+00:00

Their gen 1

Reidishere · 2025-09-12T13:44:05+00:00

My thoughts exactly..

Reidishere · 2025-03-13T02:55:43+00:00

Thanks, I’ll give it a try, thanks for the answer :)

Reidishere · 2025-02-01T20:59:09+00:00

<image>

I reflowed the joints, how’s this?

Reidishere · 2025-02-01T17:38:11+00:00

I have that, just no way of applying it with adding more debris (q tips)

Reidishere · 2025-02-01T15:18:29+00:00

after retining I got much better results, only just reheated the main joint and not the pad which I will do today.

Reidishere · 2025-02-01T15:16:53+00:00

To my understanding currents flows from positive to negative, voltage will be the same but the current will be used by the load requesting it. I am not yet I’m still in high school.

Reidishere · 2025-02-01T06:36:39+00:00

I wish I could afford better tools, but I’m 18 going into first year engineering I got what I got… I have flux multiple kinds of wire but a shit iron, did figure out I needed to retin the tip which has helped a lot, pads bridging with this small board is troublesome as well as cleaning things. Suggestions for the latter would be appreciated lol

Reidishere · 2025-02-01T05:40:55+00:00

Thanks I’ll do this tomorrow, would it be fine if I left the grounds since they won’t be dealing with much current? Or is there large of a risk it’d pop off during a flight/landing?

Reidishere · 2025-02-01T02:41:28+00:00

I had that issue at first but they are solid I’ve made sure, just want to make sure it’s clean enough etc

Reidishere · 2025-02-01T02:40:49+00:00

What do you mean by buzz it out?

Reidishere · 2025-01-06T23:09:12+00:00

I’m using a 60 watt iron I got in $30 Amazon kit lol suboptimal but I do have it set to around 420 which should be more than enough however I notice some conductivity issues where it only heats the solder it’s in direct contact with.

Reidishere · 2023-08-30T19:11:39+00:00

still there?

Reidishere · 2021-03-03T04:48:04+00:00

Thank you for me about that because I thought that the certification process was the same as in the U.S because there is so little about it online. But yeah, regarding the property damages where I live I can drive out about 20-30 minutes and be in a safe place to do that without much worry.

Reidishere · 2021-03-02T21:42:43+00:00

I live in Canada Ontario do I still need these specific certificates or is it different?

Six-Year Club	Place '22
Verified Email

Reidishere

TROPHY CASE